Jeep Grand Cherokee WK. Manual — part 91
BEARINGS-DIFFERENTIAL CASE
REMOVAL
CAUTION: Do not disturb the ELSD pump after
bearing has been removed. Failure to follow these
instructions will damage the pump seals.
1. Install Plug SP 3298 (3) Into the differential axle
shaft hole.
2. Remove differential case bearings with Puller 6444
(1), Puller Rods 6444-4 (2) and Puller Flange
6444-1(4). Position puller on the differential.
3. Position Puller (1) Jaws 9641(2) around the case
bearing and puller flange.
3 - 262
REAR AXLE - C213RE
WK
4. Position Puller (1) Collar 6444-8 (2) around the
puller jaws.
5. Tighten the puller nut and remove differential case
bearing.
INSTALLATION
CAUTION: Do not disturb the ELSD pump after
bearing has been removed. Failure to follow these
instructions will damage the pump seals.
1. Install differential case bearing with Installer C-4340
(1) and Handle C-4171 (2).
WK
REAR AXLE - C213RE
3 - 263
PINION GEAR/RING GEAR
REMOVAL
NOTE: The ring gear and pinion are serviced in a
matched set. Never replace one gear without
replacing the matching gear.
1. Remove differential from axle housing.
2. Place differential case in vise with soft metal jaw
protectors.
3. Remove ring gear bolts and drive ring gear (2) off
differential case with a soft hammer (3).
4. Hold
pinion
flange
with
Wrench
C-3281
and
remove pinion nut.
5. Remove pinion flange with two jaw puller.
6. Remove pinion from housing with a soft hammer
(1).
3 - 264
REAR AXLE - C213RE
WK
7. Remove pinion seal with a pry tool or slide-hammer
mounted screw.
8. Remove oil slinger if equipped and front pinion
bearing.
9. Remove front pinion bearing cup with Remover
C-4345 (1) and Handle C-4171 (2).
10. Remove rear bearing cup from housing with
Remover C-4307 (1) and Handle C-4171 (2).
WK
REAR AXLE - C213RE
3 - 265
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст