Jeep Liberty KJ. Manual — part 1287
4. Disconnect the exterior handle rod at the handle.
5. Disconnect the lock knob rod (1) and lock cylinder
link rod at the latch.
6. Remove the screws (5) and remove the latch
assembly (3).
7. Disconnect the electrical connectors.
INSTALLATION
1. Connect the latch electrical connectors.
2. Install the latch assembly (3) into the door (4) and
install the screws (5).
3. Tighten the latch screws (5) to 11 N·m (95 in. lbs.).
4. Connect the lock cylinder link rod and lock knob
rod at the latch.
5. Connect the exterior handle actuator rod at the
handle.
23 - 48
DOOR - FRONT
KJ
6. Install the rear glass run channel bolts (2) and
tighten to 9 N·m (80 in. lbs.).
7. Install the waterdam. (Refer to 23 - BODY/DOOR -
FRONT/WATERDAM - INSTALLATION)
8. Reconnect the battery ground cable (1).
KJ
DOOR - FRONT
23 - 49
LATCH STRIKER
REMOVAL
1. Remove the bolts (4).
2. Remove the latch striker (3) and the spacer (2), if
equipped.
INSTALLATION
1. Install the striker (3) and spacer (2), if equipped.
2. Install the bolts (4) and tighten to 28 N·m (21 ft.
lbs.).
3. Adjust the door as necessary. (Refer to 23 - BODY/
BODY STRUCTURE/GAP AND FLUSH - SPECIFI-
CATIONS)
23 - 50
DOOR - FRONT
KJ
LOCK CYLINDER
REMOVAL
1. Remove the exterior handle (1). (Refer to 23 -
BODY/DOOR - FRONT/EXTERIOR HANDLE -
REMOVAL)
2. Remove the screw (1) and remove the lock cylin-
der (2).
KJ
DOOR - FRONT
23 - 51
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст