Jeep Liberty KJ. Manual — part 929
INSTALLATION
CAUTION: Use caution when removing and install-
ing oil jets. Damage to oil jet nozzle could cause
severe engine damage. Care must be taken not to
damage the crankshaft tone ring when installing
cylinder number four oil jet.
NOTE: Carefully install the oil jets After assem-
bling the engine liners, crankshaft and pistons.
1. Lubricate o-ring on oil jet.
2. Using special tool VM.1060, install oil jet in engine
block
3. Install
oil
jet
retaining
bolt.
Torque
bolt
to
10.8N·m.(96 in.lbs.).
4. Install oil pan (Refer to 9 - ENGINE/LUBRICATION/
OIL PAN - INSTALLATION).
5. Refill engine oil to proper level.
6. Connect negative battery cable.
9 - 1674
ENGINE - 2.8L DIESEL
KJ
SEPARATOR-OIL
REMOVAL
1. Remove the engine cover.
NOTE: Inspect the oil drain back access hole in
the intake manifold/cylinder head cover to assure
that it is free of obstruction.
2. Remove
the
oil
separator
fasteners
and
oil
separator.
INSTALLATION
NOTE: Inspect the oil drain back access hole in
the intake manifold/cylinder head cover to assure
that it is free of obstruction.
1. Lubricate the oil separator o-rings with clean
engine oil.
2. Carefully position and push down on the oil sepa-
rator to seat.
3. Install the oil separator retaining fasteners. Tighten
fasteners to 10.8 N·m (96 lbs. in.).
KJ
ENGINE - 2.8L DIESEL
9 - 1675
MANIFOLD-INTAKE
DESCRIPTION
(Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - DESCRIPTION)
REMOVAL
1.
(Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL)
INSTALLATION
1.
(Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - INSTALLATION)
9 - 1676
ENGINE - 2.8L DIESEL
KJ
MANIFOLD-EXHAUST
REMOVAL
1.
(Refer to 11 - EXHAUST SYSTEM/TURBOCHARGER SYSTEM/TURBOCHARGER - REMOVAL)
INSTALLATION
1.
(Refer to 11 - EXHAUST SYSTEM/TURBOCHARGER SYSTEM/TURBOCHARGER - INSTALLATION)
KJ
ENGINE - 2.8L DIESEL
9 - 1677
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст