Jeep Liberty KJ. Manual — part 1055
29. Remove oil pump gasket (2).
CAUTION: By-pass valve must be replaced if
transmission failure occurs.
30. Remove the cooler by-pass valve (1).
31. Remove the #1 caged needle bearing (1).
21 - 264
AUTOMATIC TRANSMISSION - 42RLE
KJ
32. Remove the input clutch assembly (1).
33. Remove the #4 thrust plate (2).
34. Remove the front sun gear assembly (1) and #4
thrust washer (if still in place).
KJ
AUTOMATIC TRANSMISSION - 42RLE
21 - 265
35. Remove the front carrier/rear annulus (2) and #6
needle bearing (1).
36. Remove the rear sun gear (2) and #7 needle
bearing (1).
NOTE: The number seven needle bearing (1) has
three antireversal tabs and is common with the
number five and number two position. The orien-
tation should allow the bearing to seat flat against
the rear sun gear. A small amount of petrolatum
can be used to hold the bearing to the rear sun
gear.
21 - 266
AUTOMATIC TRANSMISSION - 42RLE
KJ
NOTE: Verify that Compressor 5058A (1) is cen-
tered properly over the 2/4 clutch retainer (4)
before compressing. If necessary, fasten the Com-
pressor 5058A bar to the bellhousing flange with
any combination of locking pliers and bolts to
center the tool properly.
37. Install and load Compressor 5058A to remove the
2/4 clutch retainer snap ring (3).
NOTE: The 2/4 Clutch Piston has bonded seals
which
are
not
individually
serviceable.
Seal
replacement requires replacement of the piston
assembly.
38. Remove the 2/4 clutch retainer (1).
39. Remove the 2/4 clutch return spring (1).
KJ
AUTOMATIC TRANSMISSION - 42RLE
21 - 267
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст