Jeep Liberty KJ. Manual — part 1434
6. Disconnect antenna cable from antenna module (2).
7. Remove antenna cable from roof panel by pulling on retaining clips.
8. Disconnect antenna cable from instrument panel antenna cable by disconnecting the antenna connector.
INSTALLATION
DOMESTIC
1. Attached wire to new cable. Pull fender out and
insert cable into opening.
2. Pull cable through hole in kick panel area using the
attached wire.
3. Connect antenna body cable to the instrument
panel cable (5).
4. Install right kick panel trim.
5. Install bezel adapter.
6. Install mounting nut.
7. Install cover.
8. Install antenna mast. Tighten to 50 N·m (37 ft. lbs.).
Ensure that the antenna mast is fully seated on
antenna base and that there is no gap between
the mast and base.
9. Tighten fender mounting bolts near door hinge
area.
10. Install and tighten the upper fender mounting bolts (Refer to 23 - BODY/EXTERIOR/FRONT FENDER -
INSTALLATION).
11. Connect the battery negative cable.
EXPORT
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt ten-
sioner, side airbag, or instrument panel component diagnosis or service. Disconnect and isolate the battery
negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before per-
forming further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take
the proper precautions could result in accidental airbag deployment and possible personal injury.
8A - 40
AUDIO/VIDEO
KJ
1. Connect antenna cable (1) to the instrument panel antenna cable.
2. Install antenna cable to the roof panel by pressing retaining clips into position.
3. Connect antenna cable to the antenna module (2).
4. Raise headliner into position.
5. Install A-pillar trim (Refer to 23 - BODY/INTERIOR/A-PILLAR TRIM - INSTALLATION).
6. Install the right side sunvisor (Refer to 23 - BODY/INTERIOR/SUN VISOR - INSTALLATION).
7. Install the assist handles (Refer to 23 - BODY/INTERIOR/ASSIST HANDLE - INSTALLATION).
8. Connect the battery negative cable.
KJ
AUDIO/VIDEO
8A - 41
ANTENNA CABLE - SATELLITE RADIO
REMOVAL
1. Disconnect and isolate the battery cable.
2. Remove headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - REMOVAL).
3. Disconnect antenna cable from antenna.
4. Remove antenna cable retainers from C-pillar and
roof panel.
5. Disconnect antenna cable from satellite receiver.
8A - 42
AUDIO/VIDEO
KJ
INSTALLATION
1. Connect antenna cable to satellite receiver.
2. Install antenna cable retainers to C-pillar and roof
panel.
3. Connect antenna cable to satellite antenna.
4. Install headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION).
5. Connect battery negative cable.
KJ
AUDIO/VIDEO
8A - 43
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст