Jeep Liberty KJ. Manual — part 1080
28. Measure OD clutch pack clearance. Set up Dial
Indicator C-3339 (1) on top of the OD/Reverse
reaction plate (2).
29. Zero dial indicator and apply 30 psi (206 kPa) air
pressure to the overdrive clutch hose on Pressure
Fixture 8391. Measure and record OD clutch pack
measurement in four (4) places, 90° apart.
30. Take average of four measurements and compare
with OD clutch pack clearance specification. The
overdrive
(OD)
clutch
pack
clearance
is
1.07-3.25 mm (0.042-0.128 in.).
If not within specifications, the clutch is not assembled
properly. There is no adjustment for the OD clutch
clearance.
31. Install reverse clutch pack (two fibers/one steel)
(1, 2).
32. Install reverse clutch reaction plate (1) with the
flat side down towards reverse clutch.
21 - 364
AUTOMATIC TRANSMISSION - 42RLE
KJ
33. Tap reaction plate (3) down to allow installation of
the reverse clutch snap ring (1). Install reverse
clutch snap ring (1).
34. Pry up reverse reaction plate (4) to seat against
snap ring (2).
35. Set up a Dial Indicator C-3339 (1) on the reverse
clutch pack (2).
KJ
AUTOMATIC TRANSMISSION - 42RLE
21 - 365
36. Using moderate pressure, press down and hold
(near indicator) reverse clutch disc (2) with screw-
driver or suitable tool and zero dial indicator (1).
When
releasing
pressure,
indicator
should
advance
0.005-0.010
inches
as
clutch
pack
relaxes.
37. Apply 30 psi (206 kPa) air pressure to the reverse
clutch hose on Pressure Fixture 8391. Measure
and record reverse clutch pack measurement in
four (4) places, 90° apart.
38. Take average of four measurements and compare
with reverse clutch pack clearance specification.
The reverse clutch pack clearance is 0.89-1.37
mm (0.035-0.054 in.). Select the proper reverse
clutch snap ring to achieve specifications.
39. To complete the assembly, reverse clutch and
overdrive clutch must be removed.
40. Install the number 2 needle bearing (1).
41. Install the underdrive shaft assembly (1).
21 - 366
AUTOMATIC TRANSMISSION - 42RLE
KJ
42. Install the number 3 thrust washer (1) to the
underdrive shaft assembly (2). Be sure five tabs
are seated properly.
43. Install the number 3 thrust plate (3) to the bottom
of the overdrive shaft assembly (1). Retain with
petrolatum or transmission assembly gel (2).
44. Install the overdrive shaft assembly (1).
KJ
AUTOMATIC TRANSMISSION - 42RLE
21 - 367
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст