Jeep Liberty KJ. Manual — part 1316
6. Remove the four nuts (3) and remove the center support bracket (2).
7. Remove the ground strap bolt and disconnect the restraint module electrical connector.
8. Position front wheels straight ahead.
9. Remove knee blocker cover and knee blocker.
(Refer to 23 - BODY/INSTRUMENT PANEL/KNEE
BLOCKER - REMOVAL)
10. Remove screws from the lower column shroud
and remove both the upper (1) and lower (2)
shrouds.
11. Turn ignition key to the on position.
12. Disconnect the automatic transmission shifter
interlock cable from the column, if equipped.
CAUTION: Do not turn the clockspring more than
90° or damage to the clockspring may occur.
13. Using a grease pencil or equivalent, mark the
position of the steering wheel.
14. Remove the steering coupler bolt and column
mounting nuts and bolts then lower column off the
mounting studs.
23 - 164
INSTRUMENT PANEL
KJ
15. Disconnect and remove the wiring harness from
the column.
16. Slide the shifter interlock cable from the tie straps.
17. Remove the steering column.
CAUTION: Do not remove the brake lamp switch.
This is a one time component and is not intended
for reinstallation. If the brake lamp switch is
removed it must be discarded and replaced with a
new switch.
18. Disconnect the brake lamp switch electrical con-
nector.
19. Remove the drivers side cowl trim cover. (Refer to
23 - BODY/INTERIOR/COWL TRIM COVER -
REMOVAL)
20. Disconnect the wire harness connector behind the
drivers side cowl trim cover.
21. Disconnect the green and light blue wire harness
bulk connectors at the junction block.
22. Disconnect the electrical connector at the inner
side of the pedal support bracket.
23. Remove the two bolts at the front of the pedal
support bracket.
24. Remove the two bolts from the bottom side of the
pedal support bracket.
KJ
INSTRUMENT PANEL
23 - 165
25. Remove the two roll down bracket bolts at the drivers cowl side panel.
26. Remove the glove box. (Refer to 23 - BODY/IN-
STRUMENT PANEL/GLOVE BOX - REMOVAL)
27. Remove the two HVAC mounting bolts behind the
center trim.
28. Remove the passenger side trim bezel. (Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL PASSENGER SIDE BEZEL - REMOVAL)
29. Remove the HVAC mounting bolt above the glove
box striker.
23 - 166
INSTRUMENT PANEL
KJ
30. Remove the HVAC bolt at the lower outside cor-
ner of the glove box opening.
31. Remove the passenger side cowl trim cover.
(Refer to 23 - BODY/INTERIOR/COWL TRIM
COVER - REMOVAL)
32. Disconnect the blower resistor electrical connec-
tor.
33. Remove the two roll down bracket bolts at the
passenger cowl side panel.
34. Disconnect the vacuum check valve and the vac-
uum reservoir.
35. Disconnect the blower motor electrical connector.
36. Disconnect the blend door connector.
37. Remove the four bolts at the top of the instrument panel connecting to the cowl front panel.
KJ
INSTRUMENT PANEL
23 - 167
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст