Jeep Liberty KJ. Manual — part 1310
FRONT WHEEL OPENING FLARE MOLDINGS
REMOVAL
1. Remove the four rivets (4) connecting the flare to
the splash shield.
2. Using a trim stick C-4755 or equivalent, separate
the upper clips (1) attaching the molding (3) to the
fender.
3. Remove the flare molding (3).
INSTALLATION
1. Position flare molding and seat clips into the
fender.
2. Install four new rivets (4) securing the flare molding
to the splash shield.
23 - 140
EXTERIOR
KJ
REAR WHEEL OPENING FLARE MOLDINGS
REMOVAL
1. Raise and support the vehicle. (Refer to LUBRICA-
TION & MAINTENANCE/HOISTING - STANDARD
PROCEDURE)
2. Remove the wheel.
3. Open the rear door and remove the five rivets (2)
from the inside surface of the door.
4. Using a trim stick C-4755 or equivalent, separate
the clips attaching the molding to the door and
remove the molding.
5. Remove the 5 rivets (3) from the rear flare (4) and
splash shield (2).
6. Using a trim stick C-4755 or equivalent, separate
the clips (1) attaching the molding (4) to the body
and the rear fascia and remove the molding.
INSTALLATION
1. Position the rear flare molding and seat the clips
(1) attaching it to the body and the rear fascia.
2. Install five new rivets (3) attaching the flare to the
splash shield (2).
KJ
EXTERIOR
23 - 141
3. Position the door flare (1) and seat the clips.
4. Install five new rivets (2) through the inside surface
of the door attaching the flare to the door.
5. Install the wheel. (Refer to 22 - TIRES/WHEELS/
WHEELS - STANDARD PROCEDURE - WHEEL
MOUNTING)
23 - 142
EXTERIOR
KJ
RADIATOR CROSSMEMBER
REMOVAL
1. Remove the grille. (Refer to 23 - BODY/EXTERI-
OR/GRILLE - REMOVAL)
2. Remove the hood latch. (Refer to 23 - BODY/
HOOD/LATCH - REMOVAL)
3. Remove the rivet securing the washer bottle to the
crossmember.
4. Remove the rivets attaching the hood latch support
to the crossmember.
5. Remove the bolts (4) and remove the hood latch
support (5).
6. Remove the bolts (3) and remove the crossmem-
ber (1).
INSTALLATION
1. Install the crossmember (1) and install the bolts (3).
2. Tighten the bolts to 10 N·m (85 in. lbs.).
3. Install the hood latch support (5) and install the
bolts (4).
4. Tighten the bolts to 10 N·m (85 in. lbs.).
5. Install new rivets (2) attaching the hood latch sup-
port to the crossmember.
6. Install the hood latch. (Refer to 23 - BODY/HOOD/
LATCH - INSTALLATION)
7. Install the grille. (Refer to 23 - BODY/EXTERIOR/
GRILLE - INSTALLATION)
8. Install a new rivet securing the washer bottle to the
crossmember.
KJ
EXTERIOR
23 - 143
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст