Jeep Liberty KJ. Manual — part 1093
22. Remove all valves and springs.
23. Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When dis-
assembling, each part should be washed in a suitable solvent, then dried by compressed air. Do not wipe
parts with shop towels. All mating surfaces in the valve body are accurately machined; therefore, careful han-
dling of all parts must be exercised to avoid nicks or burrs.
ASSEMBLY
NOTE: If the valve body assembly is being reconditioned or replaced, it is necessary to perform the Quick
Learn Procedure using the scan tool. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANS-
MISSION CONTROL MODULE - STANDARD PROCEDURE)
21 - 416
AUTOMATIC TRANSMISSION - 42RLE
KJ
1. Install all valves and springs as shown.
2. Install regulator valve spring retainer (2).
KJ
AUTOMATIC TRANSMISSION - 42RLE
21 - 417
3. Install dual retainer plate (2) using Remover/In-
staller 6301 (1).
4. Verify that all retainers (1, 2) are installed as
shown. Retainers should be flush or below valve
body surface.
5. Install
2/4
Accumulator
components
(1-5)
as
shown. Torque 2/4 Accumulator retainer plate to 5
N·m (45 in. lbs.).
21 - 418
AUTOMATIC TRANSMISSION - 42RLE
KJ
6. Install check balls into position as shown. If necessary, secure them with petrolatum or transmission assembly
gel for assembly ease.
7. Install thermal valve (1) to the transfer plate.
KJ
AUTOMATIC TRANSMISSION - 42RLE
21 - 419
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст