Jeep Liberty KJ. Manual — part 137
Possible Causes
(A908) FUSED B+ CIRCUIT OPEN
(F942) FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
(Z13) GROUND CIRCUIT OPEN
ELECTRONIC VEHICLE INFORMATION CENTER
Diagnostic Test
1.
(A908) FUSED B+ CIRCUIT OPEN
NOTE: Diagnose and repair any BCM, MIC, PCM, or COMMUNICA-
TION DTCs before proceeding.
Turn the ignition off.
Disconnect the Overhead Console harness connector.
Measure the voltage between the (A908) Fused B+ circuit and ground.
Is the voltage above 10.5 volts?
Yes
>> Go To 2
No
>> Repair the (A908) Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL
MODULES
-
STANDARD PROCEDURE)
2.
(F942) FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
Turn the ignition off.
Disconnect the Overhead Console harness connector.
Turn the ignition on.
Measure the voltage between the (F942) Fused Ignition Switch Output
circuit and ground.
Is the voltage below 10.5 volts?
Yes
>> Repair the (F942) Fused Ignition Switch Output circuit for
an open.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL
MODULES
-
STANDARD PROCEDURE)
No
>> Go To 3
8M - 10
OVERHEAD CONSOLE - ELECTICAL DIAGNOSTICS
KJ
3.
(Z13) GROUND CIRCUIT OPEN
Turn the ignition off.
Disconnect the Overhead Console harness connector.
Measure the resistance between ground and the (Z13) EVIC ground cir-
cuit.
Is the resistance above 5.0 ohms?
Yes
>> Repair the (Z13) Ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL
MODULES
-
STANDARD PROCEDURE)
No
>> Replace the EVIC in accordance with the Service Informa-
tion.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL
MODULES
-
STANDARD PROCEDURE)
KJ
OVERHEAD CONSOLE - ELECTICAL DIAGNOSTICS
8M - 11
*ANY SWITCH ON EVIC INOPERATIVE
For a complete wiring diagram Refer to Section 8W.
Possible Causes
ELECTRONIC VEHICLE INFORMATION CENTER
Diagnostic Test
1.
ELECTRONIC VEHICLE INFORMATION CENTER
NOTE: Diagnose and repair any BCM, MIC, WCM, PCM, or COMMUNICATION DTCs before proceeding
If all the possible causes above are operating correctly, view repair.
Repair
Replace the EVIC in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES - STANDARD PROCEDURE)
8M - 12
OVERHEAD CONSOLE - ELECTICAL DIAGNOSTICS
KJ
*AVERAGE MILES/GAL INOPERATIVE OR WRONG
For a complete wiring diagram Refer to Section 8W.
Possible Causes
ELECTRONIC VEHICLE INFORMATION CENTER
Diagnostic Test
1.
ELECTRONIC VEHICLE INFORMATION CENTER
NOTE: Diagnose and repair any BCM, MIC, WCM, PCM, or COMMUNICATION DTCs before proceeding
NOTE: Average Miles/Gal is calculated in the BCM. The EVIC only displays this information.
If all the possible causes above are operating correctly, view repair.
Repair
Replace the EVIC in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES - STANDARD PROCEDURE)
KJ
OVERHEAD CONSOLE - ELECTICAL DIAGNOSTICS
8M - 13
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст