Jeep Liberty KJ. Manual — part 6
FLUID CAPACITIES
SPECIFICATIONS - FLUID CAPACITIES
DESCRIPTION
SPECIFICATION
FUEL TANK – Gasoline & Diesel
19.5 U.S. Gallons (74L)*
ENGINE OIL
2.4L with Filter
4.7L (5.0 qts.)
3.7L with Filter
4.7L (5.0 qts.)
2.8L Diesel with Filter
6.0L (6.3 qts.)
ENGINE COOLANT
Cooling System - 2.4L
9.5L (10.0 qts.)
Cooling System - 3.7L
13.2L (14.0 qts.)
Cooling System-2.8L Diesel
12.5 L (11.8 qts.)
POWER STEERING SYSTEM
Power steering fluid capacities are dependent on engine/chassis options as well as steering gear/cooler options.
Depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary
cooler, these capacities may vary. Refer to 19, Steering for proper fill and bleed procedures.
AUTOMATIC TRANSMISSION
Service Fill - 545RFE
4.73L (10.0 pts)
O-haul Fill - 545RFE
13.33L (28.0 pts)
Service Fill - 42RLE
3.8L (8.0 pts)
O-haul Fill - 42RLE
8.3L (17.6 pts)
Dry fill capacity depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of
an auxiliary cooler, these figures may vary. (Refer to 21 - TRANSMISSION/AUTOMATIC/FLUID - STANDARD
PROCEDURE)
TRANSFER CASE
NV231
1.4L (2.95 pts.)
NV241 GENII
2.0L (4.2 pts.)
NV242
1.6L (3.4 pts.)
MANUAL TRANSMISSION
NSG370 (Approximate dry fill or fill to bottom edge of the
fill plug hole.)
1.5L (3.17 pts.)
FRONT AXLE
186 FIA (Model 30)
1.24L (2.6 pts.)
REAR AXLE
8 1/4
2.08L (4.4 pts.)**
*Nominal refill capacities are shown. A variation may be observed from vehicle to vehicle due to manufacturing
tolerance and refill procedure.
** When equipped with Trac-lok, include 118 ml (4.0 ounces) of Limited Slip Additive.
0 - 8
LUBRICATION & MAINTENANCE
KJ
MAINTENANCE SCHEDULES
DESCRIPTION
MAINTENANCE SCHEDULES - GASOLINE ENGINES
There are two maintenance schedules that show the required service for your vehicle.
First is Schedule
(
B
(
. It is for vehicles that are operated under the conditions that are listed below and at the begin-
ning of the schedule.
•
Day or night temperatures are below 32°F (0°C).
•
Stop and go driving.
•
Extensive engine idling.
•
Driving in dusty conditions.
•
Short trips of less than 10 miles (16.2 km).
•
More than 50% of your driving is at sustained high speeds during hot weather, above 90°F (32°C).
•
Trailer towing.
•
Heavy loading.
•
Taxi, police, or delivery service (commercial service).
•
Off-road or desert driving.
•
If equipped for and operated with E-85 (ethanol) fuel.
NOTE: If ANY of these apply to you then change your engine oil every 3,000 miles (5 000 km) or 3 months,
whichever comes first and follow “Schedule B” of the “Maintenance Schedules” section of this manual.
NOTE: If ANY of these apply to you then flush and replace your engine coolant/anti-freeze every 102,000
miles (163 000 km) or 60 months, whichever comes first, and follow “Schedule B” of the “Maintenance
Schedules” section of this manual.
NOTE: Most vehicles are operated under the conditions listed for Schedule “B.”
Second is Schedule “A”. It is for vehicles that are not operated under any of the conditions listed under Schedule
“B.”
Use the schedule that best describes your driving conditions. Where time and mileage are listed, follow the interval
that occurs first.
CAUTION: Failure to perform the required maintenance items may result in damage to the vehicle.
At Each Stop for Fuel
•
Check the engine oil level about 5 minutes after a fully warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accuracy of the oil level reading. Add oil only when the level is
at or below the ADD or MIN mark.
•
Check the windshield washer solvent, add as required.
Once a Month
•
Check the tire pressure and look for unusual wear or damage.
•
Inspect the battery, and clean and tighten the terminals as required.
•
Check the fluid levels of the engine coolant/anti-freeze reservoir, brake master cylinder, and transmission, and
add as needed.
•
Check all lights and all other electrical items for correct operation.
At Each Oil Change
•
Change the engine oil filter.
•
Inspect the exhaust system.
KJ
LUBRICATION & MAINTENANCE
0 - 9
•
Inspect brake hoses.
•
Check the engine coolant/anti-freeze level, hoses, and clamps.
•
Inspect manual transmission fluid level — if equipped.
•
After completion of off-road operation, the underside of the vehicle should be thoroughly inspected. Examine
threaded fasteners for looseness.
Schedule “B”
Follow schedule “B” if you usually operate your vehicle under one or more of the following conditions.
•
Day or night temperatures are below 32°F (0°C).
•
Stop and go driving.
•
Extensive engine idling.
•
Driving in dusty conditions.
•
Short trips of less than 10 miles (16.2 km).
•
More than 50% of your driving is at sustained high speeds during hot weather, above 90°F (32°C).
•
Trailer towing.
•
Heavy loading.
•
Taxi, police, or delivery service (commercial service).
•
Off-road or desert driving.
•
If equipped for and operated with E-85 (ethanol) fuel.
NOTE: If ANY of these apply to you then change your engine oil every 3,000 miles (5 000 km) or 3 months,
whichever comes first and follow “Schedule B” of the “Maintenance Schedules” section of this manual.
NOTE: If ANY of these apply to you then flush and replace your engine coolant/anti-freeze every 102,000
miles (163 000 km) or 60 months, whichever comes first, and follow “Schedule B” of the “Maintenance
Schedules” section of this manual.
Miles
3,000
6,000
9,000
12,000
15,000
(Kilometers)
(5 000)
(10 000)
(15 000)
(20 000)
(25 000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.
X
X
X
X
X
Rotate the tires.
X
X
Inspect the engine air filter element, replace if
necessary.
X
Inspect the brake linings.
X
Drain and refill the front and rear axle fluid‡
X
Miles
18,000
21,000
24,000
27,000
30,000
(Kilometers)
(30 000)
(35 000)
(40 000)
(45 000)
(50 000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.
X
X
X
X
X
Rotate the tires.
X
X
X
Inspect the engine air filter element, replace if
necessary.
X
Replace the spark plugs.
X
Inspect and replace the PCV valve, if necessary.
L
X
Inspect the brake linings.
X
Inspect the manual transmission fluid, add as
necessary.
X
Drain and refill the front and rear axle fluid‡
X
0 - 10
LUBRICATION & MAINTENANCE
KJ
Miles
18,000
21,000
24,000
27,000
30,000
(Kilometers)
(30 000)
(35 000)
(40 000)
(45 000)
(50 000)
Inspect the transfer case fluid, add if necessary.
X
Miles
33,000
36,000
39,000
42,000
45,000
(Kilometers)
(55 000)
(60 000)
(65 000)
(70 000)
(75 000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.
X
X
X
X
X
Rotate the tires.
X
X
Inspect the engine air filter element, replace if
necessary.
X
Inspect the brake linings.
X
Drain and refill the front and rear axle fluid‡
X
Inspect the drive belt and replace as needed.
X
Miles
48,000
51,000
54,000
57,000
60,000
(Kilometers)
(80 000)
(85 000)
(90 000)
(95 000)
(100
000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.
X
X
X
X
X
Rotate the tires.
X
X
X
Inspect the engine air filter element, replace if
necessary.
X
Replace the spark plugs.
X
Inspect and replace the PCV valve, if necessary.
L
X
Inspect the brake linings.
X
X
Drain and refill the front and rear axle fluid‡
X
Inspect the manual transmission fluid, add as
necessary.
X
Drain and refill the automatic transmission fluid,
replace main sump filter, and spin-on cooler return
filter (if equipped).†
X
Inspect the drive belt and replace as needed. Not
required if belt was previously replaced.
X
Drain and refill the transfer case fluid.
X
Flush and replace the engine coolant/anti-freeze.
X
Miles
63,000
66,000
69,000
72,000
75,000
(Kilometers)
(105
000)
(110 000)
(115
000)
(120
000)
(125
000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.
X
X
X
X
X
Rotate the tires.
X
X
Inspect the engine air filter element, replace if
necessary.
X
Inspect the brake linings.
X
Drain and refill the front and rear axle fluid‡
X
KJ
LUBRICATION & MAINTENANCE
0 - 11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст