Jeep Liberty KJ. Manual — part 30
5. Remove two starter mounting bolts (2) and remove
starter from vehicle.
2.8L - DIESEL
1. Disconnect and isolate negative battery cable.
2. Raise and support vehicle.
3. Disconnect solenoid wire connector (2) from sole-
noid terminal.
4. Remove battery cable eyelet (4) from stud on
starter solenoid.
8F - 58
STARTING SYSTEM
KJ
5. Remove three starter mounting bolts (2).
6. Remove starter (1) from transmission bellhousing.
3.7L
1. Disconnect and isolate negative battery cable.
2. Raise and support vehicle.
3. Remove 2 flange bolts securing left exhaust downpipe to crossover pipe. Lower pipe slightly to allow front pro-
peller shaft removal.
4. Remove front propeller shaft.
5. Remove two starter heat shield bolts (3) at side of
starter.
6. Remove starter heat shield nut at front of starter.
7. Remove starter heat shield.
KJ
STARTING SYSTEM
8F - 59
8. Remove solenoid wire connector (3) from solenoid
terminal.
9. Remove battery cable eyelet (2) from stud on
starter solenoid.
10. Remove two starter mounting bolts (2).
11. Position front of starter to face rear of vehicle.
Rotate starter until solenoid position is located
below starter.
12. Remove
starter
from
vehicle
by
passing
it
between
exhaust
pipe
and
transmission
bellhousing.
8F - 60
STARTING SYSTEM
KJ
INSTALLATION
2.4L
1. Position starter into bellhousing and install two
bolts (2) and tighten to 54 N·m (40 ft. lbs.).
2. Install battery cable and nut to stud on starter sole-
noid and tighten to 11 N·m (100 in. lbs.).
3. Install solenoid wire connector to solenoid terminal.
4. Lower vehicle.
5. Connect negative battery cable.
2.8L - DIESEL
1. Position starter motor (1) to transmission housing.
KJ
STARTING SYSTEM
8F - 61
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст