Jeep Liberty KJ. Manual — part 2
FASTENER USAGE
DESCRIPTION
FASTENER USAGE
WARNING: Use of an incorrect fastener may result in component damage or personal injury.
Fasteners and torque specifications references in this Service Manual are identified in metric and SAE format.
During any maintenance or repair procedures, it is important to salvage all fasteners (nuts, bolts, etc.) for reassem-
bly. If the fastener is not salvageable, a fastener of equivalent specification must be used.
THREADED HOLE REPAIR
Most stripped threaded holes can be repaired using a Helicoil
T
. Follow the vehicle or Helicoil
T
recommendations for
application and repair procedures.
4
INTRODUCTION
KJ
INTERNATIONAL SYMBOLS
DESCRIPTION
The graphic symbols illustrated in and the following International Control and Display Symbols Chart are used to
identify various instrument controls. The symbols correspond to the controls and displays that are located on the
instrument panel.
KJ
INTRODUCTION
5
METRIC SYSTEM
DESCRIPTION
The metric system is based on quantities of one, ten, one hundred, one thousand and one million.
The following chart will assist in converting metric units to equivalent English and SAE units, or vise versa.
6
INTRODUCTION
KJ
CONVERSION FORMULAS AND EQUIVALENT VALUES
MULTIPLY
BY
TO GET
MULTIPLY
BY
TO GET
in-lbs
x
0.11298
= Newton Meters
(N·m)
N·m
x 8.851
= in-lbs
ft-lbs
x
1.3558
= Newton Meters
(N·m)
N·m
x
0.7376
= ft-lbs
Inches Hg (60° F)
x 3.377
= Kilopascals (kPa)
kPa
x
0.2961
= Inches Hg
psi
x 6.895
= Kilopascals (kPa)
kPa
x 0.145
= psi
Inches
x 25.4
= Millimeters (mm)
mm
x
0.03937
= Inches
Feet
x
0.3048
= Meters (M)
M
x 3.281
= Feet
Yards
x
0.9144
= Meters
M
x
1.0936
= Yards
mph
x
1.6093
= Kilometers/Hr.
(Km/h)
Km/h
x
0.6214
= mph
Feet/Sec
x
0.3048
= Meters/Sec (M/S)
M/S
x 3.281
= Feet/Sec
mph
x
0.4470
= Meters/Sec (M/S)
M/S
x 2.237
= mph
Kilometers/Hr. (Km/h)
x
0.27778
= Meters/Sec (M/S)
M/S
x 3.600
Kilometers/Hr. (Km/h)
COMMON METRIC EQUIVALENTS
1 inch = 25 Millimeters
1 Cubic Inch = 16 Cubic Centimeters
1 Foot = 0.3 Meter
1 Cubic Foot = 0.03 Cubic Meter
1 Yard = 0.9 Meter
1 Cubic Yard = 0.8 Cubic Meter
1 Mile = 1.6 Kilometers
Refer to the Metric Conversion Chart to convert torque values listed in metric Newton- meters (N·m). Also, use the
chart to convert between millimeters (mm) and inches (in.).
KJ
INTRODUCTION
7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст