Jeep Liberty KJ. Manual — part 1201
9. Pull cable through floor panel opening.
10. Remove shift cable from vehicle.
INSTALLATION
1. Route cable through hole in floor pan.
2. Install seal plate to studs in floor pan.
3. Install nuts to hold seal plate to floor pan. Tighten
nuts to 7 N·m (65 in.lbs.).
4. Install the shift cable to the shifter assembly
bracket. Push cable into the bracket until secure.
5. Place the floor shifter lever in PARK position.
6. Loosen the adjustment screw on the shift cable.
7. Snap the shift cable onto the shift lever pin.
21 - 748
AUTOMATIC TRANSMISSION - 545RFE
KJ
8. Raise the vehicle.
9. Install the shift cable to the shift cable support
bracket.
10. Shift the transmission into PARK. PARK is the
rearmost detent position on the transmission man-
ual shift lever.
11. Snap the shift cable onto the transmission manual
shift lever.
12. Lower vehicle.
13. Verify that the shift lever is in the PARK position.
14. Tighten the adjustment screw to 7 N·m (65
in.lbs.).
15. Verify correct shifter operation.
16. Install any console parts removed for access to
shift lever assembly and shift cable. (Refer to 23 -
BODY/INTERIOR/FLOOR CONSOLE - INSTAL-
LATION)
ADJUSTMENTS - GEARSHIFT CABLE
Check adjustment by starting the engine in PARK and
NEUTRAL. Adjustment is CORRECT if the engine
starts only in these positions. Adjustment is INCOR-
RECT if the engine starts in one but not both posi-
tions. If the engine starts in any position other than
PARK or NEUTRAL, or if the engine will not start at
all, the TRS may be faulty.
Gearshift Adjustment Procedure
1. Shift transmission into PARK.
2. Remove floor console as necessary for access to
the shift cable adjustment. (Refer to 23 - BODY/IN-
TERIOR/FLOOR CONSOLE - REMOVAL)
3. Loosen the shift cable adjustment screw.
KJ
AUTOMATIC TRANSMISSION - 545RFE
21 - 749
4. Raise vehicle.
5. Unsnap cable eyelet from transmission shift lever.
6. Verify transmission shift lever is in PARK detent by
moving lever fully rearward. Last rearward detent is
PARK position.
7. Verify positive engagement of transmission park
lock by attempting to rotate propeller shaft. Shaft
will not rotate when park lock is engaged.
8. Snap cable eyelet onto transmission shift lever.
9. Lower vehicle
10. Tighten the shift cable adjustment screw to 7 N·m
(65 in.lbs.).
11. Verify correct operation.
12. Install any floor console components removed for
access. (Refer to 23 - BODY/INTERIOR/FLOOR
CONSOLE - INSTALLATION)
21 - 750
AUTOMATIC TRANSMISSION - 545RFE
KJ
CLUTCHES-HOLDING
DESCRIPTION
Three hydraulically applied multi-disc clutches are used to hold some planetary geartrain components stationary
while the input clutches drive others. The 2C, 4C, and Low/Reverse clutches are considered holding clutches. The
2C and 4C clutches are located in the 4C retainer/bulkhead (13).
KJ
AUTOMATIC TRANSMISSION - 545RFE
21 - 751
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст