Engines Iveco C10,C13, Cursor 10, Cursor 13. Manual — part 37
8
SECTION 5 - TOOLS
CURSOR ENGINES F3A
Base - May 2007
TOOL NO.
DESCRIPTION
99360613
Tool for timing of phonic wheel on timing gear
99360703
Tool to stop cylinder liners
99360706
Tool to extract cylinder liners (to be used with specific rings)
99360726
Ring (125 mm) (to be used with 99360706)
99361036
Brackets fixing the engine to rotary stand 99322230
99365056
Tool for injector holder heading
SECTION 5 - TOOLS
9
CURSOR ENGINES F3A
Base - May 2007
TOOL NO.
DESCRIPTION
99370415
Base supporting the dial gauge for checking cylinder liner
protrusion (to be used with 99395603)
99389834
Torque screwdriver for calibrating the injector solenoid
valve connector check nut
99390311
Valve guide sleeker
99390426
Male (M 17 x 2) - for a revision of threaded holes screw joint of
cylinder heads/crank case as well as crank case/under crank case
(of motor)
99390772
Tool for removing injector holding case deposits
99390804
Tool for threading injector holding cases to be extracted
(to be used with 99390805)
10
SECTION 5 - TOOLS
CURSOR ENGINES F3A
Base - May 2007
TOOL NO.
DESCRIPTION
99390805
Guide bush (to be used with 99390804)
99394015
Guide bush (to be used with 99394041 or 99394043)
99394041
Cutter to rectify injector holder housing
(to be used with 99394015)
99394043
Reamer to rectify injector holder lower side
(to be used with 99394015)
99395216
Measuring pair for angular tightening with 1/2”
and 3/4” square couplings
99395218
Gauge for defining the distance between the centres
of camshaft and transmission gear
SECTION 5 - TOOLS
11
CURSOR ENGINES F3A
Base - May 2007
TOOL NO.
DESCRIPTION
99395603
Dial gauge (0 - 5 mm)
99396035
Centering ring of crankshaft front gasket cap
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст