Iveco Stralis AT/AD. Manual — part 26
DIAGRAM FOR THE INSTALLATION OF FAN BELTS -
WATER PUMP - ALTERNATOR AND CONDITIONER
COMPRESSOR
1. Alternator - 2. Fan - 3. Water pump - 4. Crankshaft - 5.
Conditioner compressor
Complete the engine by installing or connecting the following
components:
- thermostatic unit;
- belt tensioner, water pump, alternator;
- control belt;
- belt tensioner, conditioner compressor;
- control belt.
Figure 186
Figure 187
44921
47564
To install belts (1-3), use the appropriate tools (2-4,) to work
on the tensioners, as shown by arrows.
84377
Fit the distribution cover (1).
Fit the blow-by case (7) and its gasket and then tighten the
screws (8) to the prescribed torque.
Install the filter (5) and the gaskets (4 and 6).
!
The filter (5) operation is unidirectional, therefore it
must be assembled with the two sight supports as
illustrated in the figure.
Fit the cover (3) and tighten the fastening screws (2) to the
prescribed torque.
!
Apply silicone LOCTITE 5699 on the blow-by case
(7) surface of engines fitted with P.T.O. according to
the procedure described in the following figure.
84392
Apply silicone LOCTITE 5699 on the blow-by case and form
a string (2) of
∅ 1.5 ±,
as shown in the figure.
!
Fit the blow-by case (1) within 10’ from sealer
application.
Figure 188
Figure 189
0.5
0.2
90
ENGINE F2B
S
TRALIS
AT/AD
Base - January 2003
- damping flywheel;
- fan;
- compressor;
- fuel pump;
- fuel filter and piping;
- pre-heating resistance;
- intake manifold;
- soundproof shields;
- heat exchanger;
- oil filter, lubricating the gasket;
- rockers caps;
- exhaust manifold;
- turbocharger and its oil and water piping;
- power take-off (P.T.O.) (if any) and related pipes;
- oil level stick and oil vapor vent;
- rotate the engine and install the oil rose pipe.
!
Automatic tensioners do not require further
adjustments after the installation.
47573
Figure 190
- place the gasket (4) on the oil sump (1), position the
spacer (3) and fit the sump to the engine block by
tightening screws (2) to the prescribed torque;
- electric connections and sensors;
- remove the engine from the stand and fit the starter;
- fill the engine with the oil quantity required.
ENGINE F2B
91
S
TRALIS
AT/AD
92
ENGINE F2B
S
TRALIS
AT/AD
Base - January 2003
Figure 191
44918
DETAIL A
A
Dropping oil
Pressure oil
Dropping oil
Pressure oil
Lubrication circuit
5430
LUBRICATION
Engine lubrication is obtained with a gear pump driven by the
crankshaft via gears.
A heat exchanger governs the temperature of the lubricating
oil.
The oil filter, signalling sensors and safety valves are installed
in the intercooler.
ENGINE F2B
93
S
TRALIS
AT/AD
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст