Iveco Stralis AT/AD. Manual — part 166
EXPERIMENTAL TOOLS
This heading covers the technical working drawings of the experimental tools (S.P.), used when overhauling the rear axle described
in this section, that can be made in your repair shop.
114
AXLES IN TANDEM MERITOR RP 160 E (R 2478) (INTERMEDIATE)
S
TRALIS
AT/AD
AXLES IN TANDEM MERITOR RP 160 E (R 2478) (INTERMEDIATE)
115
S
TRALIS
AT/AD
116
AXLES IN TANDEM MERITOR RP 160 E (R 2478) (INTERMEDIATE)
S
TRALIS
AT/AD
Set the rear axle assembly on the stand 99322215,
Check that the air breather (1) is not clogged; if it is, remove
it, clean it carefully and fit it back on.
77221
77222
Figure 5
Figure 6
Lock the differential gear, operating as follows: unscrew the
screw (7) and screw it down in the hole (8): screw down the
screw fully to get the differential lock to go in.
Removal/installation
operations
concerning
the
following units: axle shafts, brake shoes and drums, air
breather, differential can be performed with the unit
on the vehicle.
!
Before placing the axle assembly on the stand, loosen the
bottom plug and drain the oil.
525013
AIR BREATHER
REMOVAL-REFITTING
The identification data of the rear axle assembly RP
160E (R 2478) are given on the plate (2).
!
525010
SERVICING
INTERMEDIATE
AXLE ASSEMBLY RP 160 E (R 2478)
525030
SERVICING WHEEL HUBS
Figure 7
19341
Place a container under the wheel hub to recover the
oil.
!
Unscrew the screws (3) fixing the drive shaft (2) and extract
it from the hub (1).
Figure 8
Remove the screws fixing the drum (1) to the wheel hub (2) and
screw them down in the holes (
→) to extract the drum (1).
19349
AXLES IN TANDEM MERITOR RP 160 E (R 2478) (INTERMEDIATE)
117
S
TRALIS
AT/AD
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст