Iveco Stralis AT/AD. Manual — part 155
70
REAR AXLE 451391
S
TRALIS
AT/AD
Base - January 2003
TOOL No.
DESCRIPTION
99370616
Mounting for removal and refitting of differential
99370617
Universal mounting to support axles during removal and refitting
99371022
Pair of differential support brackets for use during overhaul (use
with 99322205-99322225)
99372211
Tool for removal and refitting of brake jaws retaining springs
99374013
Key to fit flow divider drive infeed shaft seal (use with 99370006)
99374093
Punch to fit external races of bearings (use with 99370007)
REAR AXLE 451391
71
S
TRALIS
AT/AD
TOOLS
TOOL No.
DESCRIPTION
99374094
Punch to fit external races of bearings (diameter 134 - 215 mm use
with 99370007)
99374161
Key for assembly of wheel hub internal seals
99374451
Tool for axle shaft disassembly-assembly
99389819
Torque wrench from 0 to 10 Nm with 1/4” square connection
99389821
Torque wrench from 0 to 70 Nm with 3/8” square connection
99395026
Tool to check rolling torque of hubs (use with torque wrench)
72
REAR AXLE 451391
S
TRALIS
AT/AD
Base - January 2003
TOOL No.
DESCRIPTION
99395027
Tool for differential bevel pinion shim measurement (to be used
with 99395603)
99395603
Dial gauge (0
÷5 mm)
Block the differential locking device sliding sleeve with a screw.
Remove the control cylinder threaded coupling (2) and
replace with a screw (1) (M 14 x 1.5).
Rotate the axle mechanism to facilitate engagement between
the sliding sleeve and the engagement sleeve; this will avoid
involuntary sleeve movement whilst the drive shaft is being
extracted.
Position a container under the wheel hub to recover
the oil.
39628
39627
71534
Figure 4
Figure 5
Figure 6
Before positioning the axle assembly on the overhaul stand,
drain off the oil by unscrewing the lower plug on the axle
housing.
Position the axle assembly on stand 99322215.
Unscrew the screws (1), remove the cover (3) and drain off
the oil into the container.
!
The drive shafts - brake drums and jaws - air breather
- wheel hubs differential and epicycloid reduction
units removal-refitting operations, can all be carried
out with the units fitted on the vehicle.
Epicycloid reduction gear disassembly
Disassembly
!
!
Before extracting the axle shaft make sure that the
screw has been tightened (2, Figure 5).
Figure 7
Figure 8
40338
Using an Allen wrench (2) unscrew the two screws (1) fixing
the drum; replace with the reaction screws (5). Tighten the
reaction screws and remove the drum (4) from the hub and,
using a sling (3), raise and remove.
40054
Unscrew the 3 side pinion (3) fixing screws; tighten the reaction
screws (1) and, using a sling (2), remove the support (3).
1
2
REAR AXLE 451391
73
S
TRALIS
AT/AD
525010
REAR AXLES ASSEMBLY OVERHAUL
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст