Iveco Stralis AT/AD. Manual — part 306
B
A
49837
III.8
ELECTRONIC SYSTEMS
S
TRALIS
AT/AD
Base - January 2003
Ref.
A - Black
Component
code
B - Blue
Component
code
1
Link K - Diagnosis
72021
-
-
2
-
-
-
-
3
CAN H (VDB) Line
-
-
-
4
CAN L (VDB) Line
-
-
-
5
-
-
-
-
6
-
-
-
-
7
-
-
-
-
8
Predisposition
ST14
-
-
9
Tachograph speed signal
72021
-
-
10
CAN H (ICB) Line
-
-
-
11
CAN L (ICB) Line
-
EDC signal input
8515D
12
-
-
-
-
13
CAN H (IDB) Line
-
-
-
14
CAN L (IDB) Line
-
-
-
15
-
-
-
-
16
Rev counter signal
40011
-
-
17
Rev counter signal
40011
-
-
18
Speed signal (intarder)
ST25
Power from fuse
70601
19
-
-
Mass
-
20
Predisposition
ST14
Power from fuse
70601
ELECTRONIC SYSTEMS
III.9
S
TRALIS
AT/AD
Display operation
Display varies subject to the following:
-
Key on MAR with engine off
-
Key on MAR with engine started and vehicle stationary
-
Key on MAR at vehicle speed over 15 Km/h
-
Key out
Key in MAR with engine off
Turning the key to MAR displays control of main vehicle systems.
Their presence is indicated in green, if all is OK, or yellow in case of a light anomaly/breakdown, or red in case of a serious
anomaly/breakdown, with activation of a buzzer.
After acknowledging the error, the operator presses key OK on the steering wheel and the icon appears in the lower
display layer.
Yellow color (light anomaly/breakdown):
Proceed with caution and contact a Service Network workshop as soon as possible.
Red color (serious anomaly/breakdown):
Park the vehicle on the roadside in a non-dangerous area or contact the Dealer or the 24 hour Client Center number
in unusual hours or in a decentralized area.
Two menus are available:
-
TRAVEL MENU
-
DIALOG MENU
External mirrors and lights can also be adjusted.
When the key is inserted, the present electronic systems perform a test by activating the related lights, enabling the
operator to check their efficiency (and learn of the existence of vehicle systems).
The list of systems present on the vehicle and their status can be displayed with the Multiplex system during Start-Up,
by receiving the diagnostic message from the various centers.
System Check Ok or System Check Failed information is provided at Start-Up Test end.
The defective system then sends its diagnostic message that is displayed with the icon of the defect under review.
The Multiplex system can indicate vehicle and electronic system errors. In case of an error detected by the Body Com-
puter, it sends the Instrument Cluster a message containing the following information, via the CAN line:
-
the status of the light associated to the defect (red for a serious and yellow for a slight anomaly)
-
the error code
At receipt of the error message, the Instrument Cluster displays the following in the central display area:
-
the colored icon related to the defective component or center
-
the related error code
It also advises the operator by activating the Buzzer. After recognizing the error, the operator presses key “OK” and
the central display area returns showing the previous information (virtual tool or menu).
The icon related to the error detected is stored in the lower layer of the display or with a specific warning.
No options such as to distract attention or options not related to an operation useful for vehicle operation are available
during operation, which is why the Menus available in case of a moving vehicle are reduced to the base essential and
scanning of the various displays is obtained simply with the “Menu” key (without reading the list of options).
With the vehicle stationary, scanning of the complete set of menus available is enabled with keys “Arrow up” and
“Arrow down”.
73662
LOWER
SECTION
TITLE
CENTRAL
SECTION
SL
High engine
coolant
temperature
III.10
ELECTRONIC SYSTEMS
S
TRALIS
AT/AD
Base - January 2003
TITLE
- Speed set by Cruise Control
- Speed Limiter set
- Supplementary heater enabled
- Battery voltage
- Radio/RDS information
- Telephone/ EMS message information
- Gears (downshifted/normal gears), suggested gears, auto/manual mode.
CENTRAL SECTION
- Engine oil pressure
- Engine oil level
- Consumption indicator
- Turbo pressure
- Engine oil temperature
- Reservoir, trailer, service air pressure
- Front / rear / trailer brake wear (vehicles with EBS)
- Light setting adjustment
- Mirror positioning
- Failure messages
LOWER SECTION
- Alarms
- Active functions indications (intarder, etc.)
SL
ELECTRONIC SYSTEMS
III.11
S
TRALIS
AT/AD
Optical status indicators on display
The corresponding icon appears at activation of the following functions of occurence of the following anomalies.
Meaning
Symbol
Colour
Meaning
Symbol
Colour
Pre-heating
yellow
ASR on
yellow
Cab unhooked
red
ASR off
yellow
Door open
red
Reduced ABS operation
yellow
Low front axle brake
air pressure
red
Automatic chains
yellow
Low rear axle brake
air pressure
red
Trailer without EBS/ABS
yellow
Low trailer brake
air pressure
red
Tipper body
yellow
Loading deck light
(tractor only)
yellow
Instrument Cluster trouble
red
Windscreen defroster
yellow
Low hydraulic pressure of
third steering axle
red
Minimum engine
coolant level
yellow
Low engine coolant level
red
High engine coolant
temperature
yellow
Very high engine coolant
temperature
red
Low windscreen washer
reservoir level
yellow
Low fuel level
yellow
Front axle brake wear
red
Rear axle brake wear
red
Added axle brake wear
red
Trailer ABS/EBS fault
yellow
Low level first power
steering circuit
yellow
Low level second power
steering circuit
yellow
Oil filter clogged
yellow
Air filter clogged
yellow
Fuel filter clogged
yellow
Water in fuel filter
yellow
Low engine oil level
red
Engine oil level too high
yellow
Low engine oil pressure
red
High engine oil temperature
red
Low parking brake
air pressure
red
Low air suspension pressure
red
Low trailer brake
air pressure
red
Brake wear
on a specific wheel
yellow
After recognizing the error, the operator must press OK on the steering wheel and the icon appears in the lower display section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст