Iveco Stralis AT/AD. Manual — part 181
14
AXLES 5876/4 (F 8021) - 5876/5 (F 8021) - 5886/5 (F 9021) - 5876/2 (F 8021)
S
TRALIS
AT/AD
Base - January 2003
TOOL No.
DESCRIPTION
99370006
Grip for interchangeable drifts
99370007
Grip for interchangeable drifts
99370317
Reaction lever with extension
99370628
Mount to remove and refit front axle
99370715
Guide for mounting wheel hub
99374093
Drift to mount outer bearing races (use with 99370007)
AXLES 5876/4 (F 8021) - 5876/5 (F 8021) - 5886/5 (F 9021) - 5876/2 (F 8021)
15
S
TRALIS
AT/AD
TOOLS
TOOL No.
DESCRIPTION
99374132
Key to mount internal wheel hub gasket (use with 99370006)
99374173
Parts to mount kingpin gaskets (use with 99370007)
99374405
Tool to drive in kingpin
99374530
Drift to remove and refit kingpin bearings (use with 99370007)
99388001
Wrench (80 mm) for wheel hub bearing adjustment nut
99388002
Wrench for screws securing longitudinal tie-rod and
transverse tie-rod bar lever on stub axle
16
AXLES 5876/4 (F 8021) - 5876/5 (F 8021) - 5886/5 (F 9021) - 5876/2 (F 8021)
S
TRALIS
AT/AD
Base - January 2003
TOOL No.
DESCRIPTION
99389805
Torque multiplier x 4 with square attachment input 1/2” output 3/4”
(max 1350 Nm)
99389819
Torque wrench (0-10 Nm) with square connection 1/4”
99395026
Tool to check rolling torque of hubs (use with torque wrench)
84540
Position the vehicle on level ground and chock the
rear wheels.
Remove front wheel securing nuts
Using a hydraulic jack, raise the front of the vehicle
and rest it on two support stands.
Unscrew wheel securing nuts and use hydraulic
trolley 99321024 to remove the wheels.
Use extractor 99347068 (2) to remove the tie-rod (3) ball
joint of arm (1).
Disconnect:
- air delivery lines from the membrane brake cylinders;
- electric cable (9) from the ABS transmitters;
- electric cable (11) for the brake lining wear indicators if
fitted.
Position a hydraulic jack fitted with support 99370628 under
axle (8).
Unscrew nuts (5) and remove brackets (4) attaching the leaf
spring and the stabilizing bar (7) fixing supports (6) to the axle.
Rotate the stabilizing bar (7) so as to prevent it from interfering
with the next operation.
Lower the hydraulic jack and pull out the axle (8).
Refitting
Using a hydraulic jack fitted with support 99370628,
raise the axle so that the leaf spring coupling pins are
inserted into holes in the spring seating faces on the
axle.
Refit by performing removal operations in reverse order, and
fasten screws and nuts to prescribed torque.
Figure 4
AXLES 5876/4 (F 8021) - 5876/5 (F 8021) - 5886/5 (F 9021) - 5876/2 (F 8021)
17
S
TRALIS
AT/AD
520610 REMOVING AND REFITTING AXLE
Removal
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст