Iveco Daily. Manual — part 347
- Remove the glove compartment by following the
procedure described above.
- Disconnect the electrical connection (1), remove the
anti-frost sensor (2) through the slot A illustrated in the
detail after turning over the bottom door on the
passenger side.
- Turn over the bottom door on the passenger side.
- Disconnect the electrical connections (1) and (2).
- Unscrew the fixing screws (3) and remove the electronic
control (4).
- Turn over the bottom door on the passenger side (1).
- Disconnect the electrical connections (2) and (3).
- Unscrew the fixing screws (4) and remove the control
unit (5).
52296
52297
52298
Figure 30
Figure 31
Figure 32
553248
Air-conditioner unit control unit
Removal - Refitting
Removal
Refitting
Refit the control unit by carrying out the operations
described for removal in reverse order.
ELECTRONIC CONTROLLER
Removal - Refitting
Removal
Refitting
Refit the control unit by carrying out the operations
described for removal in reverse order.
ANTI-FROST SENSOR
Removal - Refitting
Removal
Refitting
Refit the anti-frost sensor by carrying out the
operations described for removal in reverse order.
30
CAB AIR-CONDITIONING
D
AILY
REPAIRS
- Remove the fascia covering, following the procedure
described above.
- Disconnect the electrical connection (3) from the
activator, (2) located at the point shown in the figure.
- Unscrew the fixing screws (1) and remove the activator
(2) from its seat.
Refitting
Refit the radiator by carrying out the operations for
removal in reverse order, taking care to replace the
seals (1) and (6) if they are damaged.
- Remove the seal clamp.
- Disconnect the pipes from the heater.
- Remove the fascia covering, following the procedure
described above, so as to access the radiator fixing
points.
- Unscrew the screw (2) securing the stand anchoring the
pipe (3), unscrew the screw (4) securing the pipes to the
heater.
- Extract the radiator (5) from the heater and remove the
seals (1) and (6).
Refitting
Refit the electric fan by carrying out the operations
for removal in reverse order, taking care to replace
the gasket (6) if it is damaged.
- Turn over the bottom door on the passenger side,
following the procedure described above.
- Disconnect the electrical connections (1), (2) and (3).
- Unscrew the screw (7) and remove the connector
bracket (8) to access the fixing screw (4).
- Unscrew the fixing screw (4), remove the electric fan (5)
and the gasket (6).
Removal
52299
52300
Figure 33
Figure 34
553215
HEATER RADIATOR
Removal - Refitting
Removal
- Drain off the engine coolant.
- Unscrew the fixing screws and move the expansion tub
to one side so as to be able to access the heater coolant
inlet/outlet couplings.
553252
MIXING ACTIVATOR
Removal - Refitting
Removal
Figure 35
52301
Refitting
For refitting, carry out the procedure described for
removal in reverse order.
Removal - Refitting
CAB AIR-CONDITIONING
31
D
AILY
553237
ELECTRIC FAN
- Remove the fascia covering and partially remove the
heater unit, without taking it out of the vehicle, following
the procedure described above, to access the sensor.
- Disconnect the electrical connection (2), lift up and
remove the sensor (1) from the heater unit.
- Remove the glove compartment, following the
procedure described above.
- Disconnect the electrical connection (1) from the
actuator, located at the point shown.
- Unscrew the fixing screws (3) and remove the actuator
(2) from the heater unit.
52302
52303
Figure 36
Removal - Refitting
Removal
Refitting
Refit the unit by carrying out the procedure
described for removal in reverse order, checking the
cogged sector couples correctly.
Refitting
For refitting, carry out the procedure described for
removal in reverse order.
Removal - Refitting
Removal
553253
AIR INTAKE ACTUATOR
553241
TREATED AIR SENSOR
Figure 37
32
CAB AIR-CONDITIONING
D
AILY
52304
Figure 38
- Remove the heater/air-conditioner unit, following the
procedure described in the above figures.
- Disconnect the electrical connections from the actuators
and sensors.
- Lift up and remove the temperature sensors (1) and (11).
- Remove the adhesive strip from the duct connection bay,
unscrew the fixing screws (10) and take out the moulding
(9) complete with drain pipe and control unit.
- Unscrew the screws securing the pipe (6), the screw (8)
securing the bolt (7) and carefully remove the radiator (5)
from the heater.
- Unscrew the fixing screws (4) and separate the front (3)
and rear (2) boxes.
- Remove the air duct gasket (13).
- Take out the evaporator unit (12) with the expansion
valve and pipe.
Refitting
For refitting, carry out the procedure described for
removal in reverse order, taking care to replace the
radiator and evaporator gaskets if they are damaged.
Removal - Refitting
Removal
CAB AIR-CONDITIONING
33
D
AILY
553231
EVAPORATOR UNIT
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст