Iveco Daily. Manual — part 255
100
REAR AXLES 450310
D
AILY
Revi - February 2005
TOOL NO.
DESCRIPTION
99341010
Pair of retainers
99341011
Pair of retainers
99341015
Clamp
99345057
Extractor reaction block
99355087
65 mm. diam. box wrench for disassembly - assembly wheel hub locking
ring
99370006
Handle, interchangeable drift
REAR AXLES 450310
101
D
AILY
Revi - February 2005
TOOL NO.
DESCRIPTION
99370007
Grip for interchangeable punches
99370286
Tool for measuring thickness of bevel pinion adjustment rings (to be
used with 99395728)
99370317
Lever and relevant extension bar to retain flanges
99370497
Tool for assembly of wheel hub
99370498
Tool for assembly of wheel hub bearing and phonic wheel
99370617
Axle universal support during removal/installation
102
REAR AXLES 450310
D
AILY
Revi - February 2005
TOOL NO.
DESCRIPTION
99374091
Punch to fit external races of bearings (diameter 55
÷ 69 mm use
with 99370007)
99374092
Punch to fit external races of bearings (diameter 69
÷ 91 mm use
with 99370007)
99374456
Key to fit differential bevel pinion gasket (use with 99370006)
99389819
Torque wrench (0 to 10 mm) with 1/4” square attachment
99395728
Dial gauge with support to be used with the tools to determine the
adjustment thickness of the bevel pinion
Figure 5
Figure 6
Figure 7
Figure 8
525010
OVERHAULING THE REAR AXLE
ASSEMBLY
Before positioning the rear axle assembly on the stand for
overhauling, drain oil by loosening rear axle casing plug (2).
Set the entire rear axle assembly on stand 99322215.
Take out the screws (1) and remove the brake caliper with
its brake linings from the mounting.
525013
Air breather disassembly - assembly
Remove braking gaskets (1). Remove screws (2), then take
support (3) off the rear axle case flange.
The caliper must not be violently knocked or
dropped.
Prevent the rubber caps coming into contact with
sharp metal tools.
Do not dirty or wet the rubber caps with mineral
grease or oil.
Do not dirty the pads with liquids or grease.
Check the conditions of brake caliper and relating
braking shoes as described in brake section.
The identification data of the rear axle unit are
given on the plate (1) fixed near to the leaf spring
attachment support.
NOTE
The drive shafts, brake disc and calipers, air
breather and differential can all be removed and
refitted even with the unit mounted on the vehicle.
NOTE
101963
101964
101965
101966
525030
Wheel hub overhaul
Disconnect the pipe (2) from the support bracket (1)
Remove caps (3), take off screws (4), then remove brake
caliper (5) from support (6).
The thread of the screws (4) securing the brake
caliper is treated with adhesive. Therefore, they
must not be reused, but replaced with new ones
every time they are removed.
NOTE
NOTE
REAR AXLES 450310
103
D
AILY
Revi - February 2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст