Iveco EuroCargo (12 to 26 t). Manual — part 198
Figure 33
SHORT CAB REAR SUSPENSION
78701
78700
E
URO
C
ARGO
T
ECTOR
12-26 t
24
BODY - CHASSIS
Base — February 2003
TORQUE
Nm
(Kgm)
1
Self-locking hexagonal nut with flange and hexagonal screw with flange to secure
bracket to chassis
179
± 18
(17.9
± 1.8)
2
Self-locking hexagonal nut to secure shock absorber and elastic bumper to cross
member on upper side
216.5
± 21.5
(21.6
± 2.1)
3
Self-locking nut and hexagonal screw for shock absorber fastening on lower side
189
± 19
(18.9
± 1.9)
Figure 34
DOUBLE AND LONG CAB REAR SUSPENSION
78702
E
URO
C
ARGO
T
ECTOR
12-26 t
BODY - CHASSIS
25
Base — February 2003
TORQUE
Nm
(Kgm)
1
Bumper securing screw
128
± 52
(12,8
± 5,2)
2
Screw to secure bracket to chassis
105
± 21
(10,5
± 2,1)
3
Screw to secure cross member connecting pipe
263
± 53
(26,3
± 5,3)
4
Screw to secure shock absorber
128
± 52
(12,8
± 5,2)
E
URO
C
ARGO
T
ECTOR
12-26 t
26
BODY - CHASSIS
Base — February 2003
TOOL No.
DENOMINATION
99370147
Cab mechanic suspension spring check tool
99378031
Two-vacuum cup grip pair to lift windows
78706
41851
38600
33911
Figure 35
Figure 36
Figure 37
Figure 38
554243
Replacing cab suspension front and
rear shock absorbers
In order to disassemble front shock absorbers (Figure 35), just
unscrew nuts (2) end take out screws (1). In order to
disassemble rear shock absorbers, it is needed to unscrew
fastenings and dodge aspiration duct (3), as well as take out
screws (1).
To fit them, carry out the above steps in the appropriate
reverse order.
Remove the bumper bar assembly.
Disconnect the shock absorber.
Support the cab with the specific prop.
Arrange the appropriate tool 99370147 (1) to compress the
mount spring.
Unscrew the mount fixing screws.
Unscrew the screws fixing the top mount to the cab and the
ones fixing the bracket (2) to the chassis frame. Then extract
the mount together with the stabilizer bar.
5542
Cab anchoring
Repairs are limited to replacing broken parts.
554215
Removing-refitting
front
mounts
and cab stabilizer bar
The tool (2) compressing the spring of the mount (3) is
removed and refitted with a press (1).
Replace all worn or broken parts.
For refitting, carry out the steps performed for removal in
reverse order.
!
When mounting the stabilizer bar, grease the grooves
of the bar with TUTELA Z2 grease to prevent noise
and wear.
E
URO
C
ARGO
T
ECTOR
12-26 t
BODY - CHASSIS
27
Base — February 2003
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст