Iveco EuroCargo (12 to 26 t). Manual — part 134
E
URO
C
ARGO
T
ECTOR
12-26 t
80
FRONT AXLE 5871/5
Base - February 2003
TOOL No.
DESIGNATION
99370006
Handle for interchangeable beaters
99370007
Handle for interchangeable beaters
99370317
Reaction lever with extension for flange holder
99370628
Support for axle detachment and reattachment
99370715
Rail for wheel hub assembly
99374093
Beater for assembly of bearing outside tracks (91 — 134) to be used
with 99370007
E
URO
C
ARGO
T
ECTOR
12-26 t
FRONT AXLE 5871/5
81
Base - February 2003
TOOL No.
DESIGNATION
Locking ring for assembly of inside wheel hub gasket
(to be used with 99370006)
99374132
99374173
Locking ring for assembly of lower steering knuckle pin gasket
(to be used with 99370007)
Tool for steering knuckle pin setting
99374405
Beater for disassembly and reassembly of steering knuckle pin
bearings (to be used with 99370007)
99374530
Wrench (80 mm) for wheel hub bearing adjusting nut
99388001
Wrench for cross and longitudinal tie rod lock screws on steering
knuckle
99388002
E
URO
C
ARGO
T
ECTOR
12-26 t
82
FRONT AXLE 5871/5
Base - February 2003
TOOL No.
DESIGNATION
99389819
Dynamometric wrench (0 — 10 Nm) with square connection 1/4”
99395026
Tool for hub rolling torque check (to be used with dynamometric
wrench)
Before checking, it is necessary to make a preliminary
investigation of some vehicle elements which can affect set
up. If any fault is detected, it is important to eliminate it in
order to avoid wrong measurements.
The checks to be made are the following:
- tyre pressure;
- wheel hub bearing clearance;
- clearance between track rod pins and levers on steering
knuckles;
- shock-absorber efficiency;
- wheel rims must not be dramatically distorted.
Make wheel set up check using equipment 99305354.
FRONT WHEEL SET UP
!
Checks and possible adjustments of wheel set up
must be made with the vehicle having static load.
By and then, check perfect calibration of optical
units.
Figure 10
Place the vehicle with the wheels in upright direction on a flat
surface. Lift the vehicle’s rear part and place the platforms
under the wheels (3). Lower the vehicle, brake the rear
wheels and set the hook (1) with the ruler (2).
32973
Figure 11
Figure 12
Lift the vehicle’s front part and place the swinging plates (1)
under the wheels, clamping them with the appropriate locks
(2).
32974
32975
Place on the wheel rim the self-centring clip (2) fitted with the
right lock pins (1). Use the handle (3) to clamp the clip on
wheel, checking that the wheel itself is well fixed.
Figure 13
Set the detecting system (3) on the clips (1) and clamp it with
the screw (2). Repeat the same operations on the other
wheel.
32976
!
Setting of clips and headlights
E
URO
C
ARGO
T
ECTOR
12-26 t
FRONT AXLE 5871/5
83
Base - February 2003
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст