Geely FC. Manual part — 82
Geely FC. Manual part - 82
Windshield/bodywork glass/wing mirror--Rear ventilation window
figure.
A: 40mm
B: 8mm
17. Assemble rear ventilation window inboard sealed
tape [68000105]
Stick sealed tape with double faced adhesive tape on both
sides.
18. Assemble rear ventilation window assembly
[68000103]
(a) Put rear ventilation window at the right position.
(b) Inspect the contacting part of rear ventilation window brim
whether it is flat.
(c) Mark signal between bodywork and glass.
(d) Disassemble rear ventilation window
(e) Use blade to remove coarseness area.
Note: leave agglutinant as much as possible on the
bodywork.
(f) Use duster cloth with cleaner to clean the agglutinant on
the cutting surface.
Clues on: When all the agglutinant has been removed
completely, clean the bodywork.
(g) Use brush to daub M priming paint on the contacting part
of bodywork.
Notes:
z
Dry M priming paint for three minutes.
z
Do not daub M priming paint on the agglutinant.
z
Opened M priming paint can not use for the next
time.
(h) Use brush or sponge to daub G priming paint on the front
windscreen brim and contacting interface.
(i) When daub other areas beside regulations, use clean duster
325
Bond
Bond
Windshield/bodywork glass/wing mirror--Rear ventilation window
cloth to clean before priming paint gets dry.
Clues on:
z
Use G priming paint over three minutes.
z
Opened G priming paint can not use for the next
time.
(j) Cut a hole on glue canister sharp nose.
(k) Put the glue canister in the sealed glue jet gun.
(l) Daub agglutinant on the front windscreen.
A: 12mm
B: 8mm
C: 6.5mm
D: 13mm
19. Disassemble rear seat back assembly (fixed)
[68010076] (referring to page 354)
20 Disassemble rear right side back assembly
(separate) [68010079] (referring to page 352)
21. Disassemble rear seat left side back assembly (separate) [68010078] (referring to page
352)
326
Windshield/bodywork glass/wing mirror--Fogbroom system
Fog defrost system
Position drawing
Malfunction
All demists (defrosts) do not work
Rear ventilation window Demist (defrost)
do not work
electric rear mirror defrost dose not work
components name
1. DEF main relay
2. DEF-IP fuse
3. DEF-m fuse
4. demist switch
5. wiring harness
1. demist wire
2. wiring harness
1. electric rear mirror
reference pages
Malfunction phenomena table
Demist (Defrost)switch
327
Demist wire
Windshield/bodywork glass/wing mirror--Fogbroom system
Inspect
1. Inspect the relay
Inspect the conduction of rear window demist(defrost) relay
(mark: DEF)
If the conduction does not accord with the regulations, replace
relay.
328
Conditions
avometer terminals
regular situations
Always
1-2
conduction
Supply battery voltage
between terminal1 and
3-5
conduction
Terminal2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст