Geely Emgrand X7. Manual part — 644
Geely Emgrand X7. Manual part - 644
Test items
Specified value
SO32(31)—CA29(1) resistance value
Less than 1Ω
SO32(32)—CA29(3) resistance value
Less than 1Ω
SO32(16)—CA29(2) resistance value
Less than 1Ω
CA29(1)—effective grounding voltage value
10 kΩ or higher
CA29(3)—effective grounding voltage value
10 kΩ or higher
CA29(2)—effective grounding voltage value
10 kΩ or higher
CA29(1)—effective grounding voltage value
0V
CA29(3)—effective grounding voltage value
0V
CA29(2)—effective grounding voltage value
0V
CA29(1, 2, 3)Inter-voltage value
10 kΩ or higher
Are all tests normal?
3
Inspect the power and grounding circuit of the parking radar control module.
(a) Refer to 11.12.6.10 System can't self-inspect (buzz doesn't make a sound)
Confirm whether various tests are normal.
4
Replace right side sensor.
(a) Replace right side sensor, refer to11.12.7.2 parking motor sensor replacement .
5
Inspect the parking radar self-inspection function to confirm the fault has been
removed.
Next
No
Repair or replace the harness.
Yes
No
Repair or replace the harness.
Yes
2575
11.13.7 Removal and installation
11.13.7.1 Replace parking radar module
Dismantlement procedure
Warning!
Warning: refer to warning on battery
disconnection in warnings and
precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. For dismantling of upper
trimming plate on the left of rear
column, refer to 12.9.1.10
Replacement of rear column
upper trimming plate assembly.
3. Disconnect
parking
motor
module harness connector.
NL11-0104b
4. Dismantle fixing bolt of parking
radar sensor.
NL11-0105b
Installation procedure:
1. Install and tighten parking radar
module fixing bolt.
Torque:5 Nm(Metric) 3.7 lb-ft(English
system)
NL11-0105b
2576
2. Connect parking radar module
wire harness connector.
3. Install trimming plate on left side
of boot.
4 Connect the battery negative
cable.
NL11-0106b
2577
11.13.7.2 Parking motor sensor replacement
Replacement of rear parking radar sensor
Dismantlement procedure
Warning!
Warning: refer to warning on battery
disconnection in warnings and
precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. For dismantling of rear bumper,
refer to 12.4.3.3 Replacement of
rear bumper.
3. Disconnect the harness connector
of the parking radar sensor.
NL11-0107b
4. Dismantle fixing retaining plate
of parking radar sensor.
5. Extract the parking radar sensor.
NL11-0108b
Installation procedure:
1. Install parking radar sensor onto
rear bumper.
2. Install parking motor sensor
fixing clamp plate.
NL11-0109b
2578
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст