Geely Emgrand X7. Manual part — 662
Geely Emgrand X7. Manual part - 662
12.3.3.5 Filler cap open handle and cable replacement
Dismantlement Procedure:
1. For dismantling of driver's seat, refer to
11.9.8.1
Replacement of front electric seat.
2. For dismantling of trimming plates on driver and
rear row passenger left door, refer to
12.9.1.1
Replacement of left/ right front doorsill inner
trimming plate assembly.
3. For dismantling of lower inner trimming plate of
middle column, refer to
12.9.1.3 Replacement of
trimming plate of middle column.
4. Remove the door-side carpet and the fixing bolt
on the release handle of the filler cap.
NL12-0114b
5. For removal of the trunk interior, refer to
12.9.1.5
Replacement of Rear Pillar Lower Trim Panel.
6. Dismantle Open Stay Guy Release Lock Catch 1
in the trunk.
Notes:
Firstly rotate counterclockwise to unlock the lock
catch 1, and then pull out the lock catch from the lock
catch holder 2.
7. Dismantle the lock catch bearing seat 2 from the
filler pipe side.
8. Detach the control cable from the harness buckle
of the underframe to extract the control cable.
2
1
NL12-0115b
Installation Procedure:
1. Install filler cap cable handle fixing bolt.
Torque: 9Nm (Metric system) 6.7lb-ft (English
system)
2. Arrnage
cable.
Notes:
The cable position shall be consistent with that
before dismantling.
NL12-0116b
2647
3. Insert buckle support 2 into the groove of filling
pipe.
4. Install Release Latch 1 into Latch Seat 2.
5. Install the boot interior.
6. Install the lower trim panel for the center pillar.
7. Install the threshold trim panels on the driver side
and left side of the rear row seat.
8. Assemble driver chair.
2
1
NL12-0115b
2648
12.3.3.6 Back-door cylinder core replacement
Dismantlement Procedure
1. For removal of the back door interior, refer to
12.9.1.10 Replacement of Back Door Trim Panel.
2. Disconnect back door lock core connecting rod
from back door lock.
NL12-0117b
3. Dismantle fixing nut of back door lock catch.
4. Remove the back door lock cylinder.
NL12-0118b
Installation Procedure:
1. Install back door lock core, and tighten nut.
Torque:10Nm(Metric) 7.4lb-ft(English system)
NL12-0118b
2649
2. Insert back door lock catch into back door lock.
3. Install the back door interior.
NL12-0117b
2650
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст