Geely Emgrand X7. Manual part — 633
Geely Emgrand X7. Manual part - 633
11.11.7.3 Rear windscreen glass defrost switch replacement
Dismantlement procedure
Warning!
Warning: refer to warning on battery disconnection in warnings and precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. Dismantle the instrument panel
center switch assembly. Refer to
8.2.8.1 replacement of
air-conditioning control panel.
3. Dismatle back door glass
defroster switch from central
switch assembly of instrument
panel.
NL11-0100b
Installation procedure:
1. Install back door glass defrosting
switch onto instrument panel
central switch assembly.
2. Install central switch assembly of
instrument panel onto control
panel of air conditioner.
3. Install the air-conditioning
control panel.
4. Connect the battery negative
cable.
NL11-0101b
2531
11.11.7.4 Woven leading wire repair of rear windscreen glass defrost
Notes:
The rear windshield defroster bus lead
or terminal can be reconnected
through re-brazing. Weld through a
welding rod containing 3% of silver
and rosin.
1. Before welding lead line of CAN,
it is necessary to clean repair
position to bright condition with
fine steel wire.
2. Apply a little amount of resin to
repair positions of lead wire and
CAN line by using brush.
3. Use soldering iron to dip welding
material enough to ensure repair
use.
4. Only apply the heat sufficient to
melt the solder. Be sure not to
overheat the conductor when
leading the re-soldered bus.
NL11-0102b
2532
11.12 Horn
11.12.1 Specification
11.12.1.1 Fastener specifications
Torque range
Fastener name
Model
Metric (N·m)
English system
(lb-ft)
Fastening bolt of electric horn
device
M8×16 18
-
22
13 — 16
11.12.1.2 Horn specification
Sound level
105-118dB
Treble 500±25Hz
Audio frequency
Bass 400±25Hz
11.12.2 Description and operation
11.12.2.1 Description and operation
The horn is arranged in the engine cabin and fixed at the both sides of the radiator at the front of
the vehicle. The high tone horn arranged at the right side and the bass horn arranged at the left side
are controlled by a steering wheel horn switch jointly. When the steering wheel horn button is
pressed down, the horn circuit is electrified, so that the horn makes a sound.
A compound horn is used as anti-theft horn at the same time, which is driven to beep by
controlling the relay grounding through the BCM.
11.12.3 System work principle
11.12.3.1 System operating Principle
The control mode of the horn is to control the power supply end, i.e., the horn switch controls the
closing of the horn relay, then the relay provides supply to the horn; and the horn is normally
grounded. The BCM controls the grounding of the relay and sounding by the horn to achieve an
anti-theft action.
2533
11.12.4 Part position
11.12.4.1 Component position
Horn
1
3
2
NL11-2188b
1. High-pitch
horn
2. Bass
horn.
3. Engine hood plunger latch
2534
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст