Geely Emgrand X7. Manual part — 660
Geely Emgrand X7. Manual part - 660
8. Install the side trim panel of the ventilation cover
plate.
9. Install
the
headlamp.
10. Install doorsill lower trimming plate.
11. Install the front fender liner.
12. Install the wheel.
13. Lower the vehicle.
14. Install front bumper support and front bumper.
NL12-0130b
2639
12.3 Rear end of body
12.3.1 Specification
12.3.1.1 Fastener specifications
Torque Range
Fastener Name
Model
Metric (NM)
English system
(lb-ft)
Fixing bolt of filler cap opening handle
M6×20
7-9
5.2-6.7
Back door handle fixing nut
M6
8-10
5.9-7.4
Back door lock catch fixing bolt
M8×22
18-22
13.3-16.3
Back door lock cylinder assembly
M6
8-10
5.9-7.4
Back door hinge assembly
M8×35
22-26
16.3-19.3
12.3.2 Part position
12.3.2.1 Component position
1
2
NL12-1025b
1. Release handles of fuel tank cap
2. Cable of fuel tank cap
2640
12.3.3 Dismantle and install
12.3.3.1 Back-door and back-door hinge replacement
Dismantlement Procedure
Warning!
Warning: Refer to Warning on Battery
Disconnection in Warnings and Precautions.
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery Cable Disconnection/Connection
Procedures
.
2. Turn on and support back-door.
3. For dismantling of rear column trimming plate,
refer to
12.9.1.6 Replacement of upper trimming
plate assembly of rear column
.
4. Disconnect back door wire harness connector.
NL12-0104b
5. For removal of the back door interior, refer to
12.9.1.10 Replacement of Back Door Trim Panel
.
6. For dismantlement of the strut bar of the back
door, refer to
12.3.3.2 Replacement of Back Door
Air Spring.
7. For dismantlement of rear wiper nozzle, refer to
11.5.8.6 Replacement of Rear Wiper Nozzle
.
8. Remove the 2 left and 2 right connecting bolts of
the back door hinge.
NL12-0105b
9. Dismantle the back door with the help from the
assistant.
10. Dismantle 2 fixing nuts respectively on left and
right sides of back door hinge fixing plate.
11. Dismantle rear back-door hinge
NL12-0106b
2641
Installation Procedure:
1. Install rear back door hinge fixing plate, and
tighten nut.
Torque: 25Nm (Metric) 18. 5lb-ft(English system)
NL12-0106b
2. Install rear back door to hinge fixing plate, and
tighten bolt.
Torque: 25Nm (Metric) 18. 5lb-ft(English system)
3. Pass wire harness connector from top section to
boot, and connect wire harness connector.
4. Install rear wiper nozzle.
5. Install the boot interior.
6. Install the back door interior.
NL12-0105b
2642
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст