Geely Emgrand X7. Manual part — 89
Geely Emgrand X7. Manual part - 89
7. Dismantle the fixing bolts of fuel
distributing pipe and dismantle
the fuel distributing pipe.
8. Dismantle retaining clips of fuel
injector and pull out the fuel
injector.
NL02-0392b
Installation Procedure:
1. Apply a small amount of engine
lubrication oil to lubricate the
fuel injector O-ring.
NL02-0393b
2. Install retaining clips of fuel
injector to ensure that the fuel
injector harness connector and
the fuel rail mounting hole are in
the same direction.
3. Install the fuel distributing pipe
assembly and tighten the fixing
bolts.
Torque:10 Nm(Metric) 7 lb-ft(English
system)
4. Connect engine fuel injector
wiring harness connector.
5. Connect the fuel distributing pipe
into fuel rail.
Note: Fuel pipe must be inserted into
the fuel distributing pipe after the
second boss and then tighten.
NL02-0392b
6. Connect crankcase ventilation tube.
7. Install the plastic shield of engine.
8. Connect the battery negative cable .
355
2.3.8.6 Fuel Tank Emission Procedure
Warning: forbid discharging or storing fuel in an open container. Must use the accepted fuel
storage container to reduce the potential of fire and explosion.
Warning: prior to the execution of the maintenance procedure on the vehicle, prepare a dry
chemical (B) fire extinguisher nearby. Not following these precautions may cause personal
injury.
1. Dismantle the fuel filler cap.
2. Install to the fuel pipe and keep
the fuel filler cap open.
3. Insert into the fuel tank until the
hose touching the floor.
4. Use the pneumatic pump to drain
the fuel through the fuel pipe as
much as possible.
NL02-0395b
356
2.3.8.7 Replacement of Fuel Tank Assembly
Dismantlement Procedure
Warning: Refer to "Warning on Release Fuel Pressure" in "Warnings and Precautions".
Warning: Refer to "Warning on Battery Disconnection" in "Warnings and Precautions".
1. Release
fuel
pressure. Refer to
2.3.6.1 Fuel Pressure Release
Procedure.
2. Disconnect the battery negative
cable. Refer to 2.12.6.1 Battery
Cable Disconnection/Connection
Procedures.
3. For exhaust of fuel tank, refer to
2.3.8.6 Exhaust procedures of
fuel tank.
4. Disconnect the fuel level sensor
wiring harness connector.
NL02-0396b
5. Loosen the fuel tank inlet hose
clamp and separate the fuel tank
inlet hose and the fuel tank
assembly.
NL02-0397b
6. Disconnect the left-front fuel
tank inlet pipe and canister hose.
NL02-0398b
357
7. Detach the carbon canister
pipeline fixed on the fuel tank.
NL02-0399b
8. Disconnect the front inlet
ventilation hose.
NL02-0400b
9. Support the fuel tank.
10. Dismantle the fixing bolts of the
mounting strap in the rear of the
fuel tank.
NL02-0401b
358
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст