Geely Emgrand X7. Manual part — 230
Geely Emgrand X7. Manual part - 230
2.12.8.2 Engine coolant temperature sensor
Dismantlement Procedure
Warning: Refer to Warning on Battery Disconnection in Warnings and Precautions.
1. Release pressure in the cooling
system.
2. Disconnect the battery negative
electrode cable.
Refer
to
2.12.6.1 Battery Disconnection.
3. Disconnect the temperature
sensor of engine coolant harness
connector.
4. Dismantle the temperature sensor
of engine coolant.
NL02-0056b
Installation Procedure:
1. Apply sealant on the temperature
sensor of engine coolant thread.
2. Install the temperature sensor of
engine coolant.
3. Connect temperature sensor of
engine coolant harness connector.
4. Fill the engine coolant.
5. Connect battery negative cable.
NL02-0057b
919
2.12.8.3 Replacement of Intake Pressure Temperature Sensor
Dismantlement Procedure
Warning: Refer to Warning on
Battery Disconnection in
Warnings and Precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 Battery
Cable Disconnection/Connection
Procedures.
2. Disconnect intake pressure
temperature sensor harness
connector.
3. For dismantling of air intake
manifold assembly, refer to
2.6.8.6 Replacement of air intake
manifold assembly.
NL02-0061b
4. Dismantle the fixing bolts of
sensor.
NL02-0062b
5. Pull out the intake pressure
temperature sensor.
NL02-0063b
920
Installation Procedure:
1. Clean the intake pressure
temperature sensor installation
position and apply new seals.
Note: the seal ring is a single use
piece, which must be replaced by a
new one after disassembling at every
turn.
NL02-0064b
2. Install the fixing bolts of sensor.
Torque:10Nm(Metric) 7.4lb-ft(English
system)
3. Install air intake manifold
assembly.
4. Connect the intake pressure
temperature sensors harness
connector.
5. Connect the battery negative
cable.
NL02-0065b
921
2.12.8.4 Replacement of Electronic Acceleration Pedal Assembly
Dismantlement Procedure
Warning: Refer to Warning on
Battery Disconnection in Warnings
and Precautions.
1. Disconnect the battery negative
cable. Refer to 2.12.6.1 Battery
Cable Disconnection/Connection
Procedures.
2. Disconnect the acceleration pedal
assembly harness connector.
NL02-0058b
3. Dismantle the fixing bolts of
acceleration pedal and dismantle
the acceleration pedal.
NL02-0059b
Installation Procedure:
1. Install the acceleration pedal and
tighten the fixing nuts.
Torque:15 Nm(Metric) 11
lb-ft(English system)
2. Connect the acceleration pedal
harness connector.
3. Connect the battery negative
cable .
NL02-0059b
922
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст