Geely Emgrand X7. Manual part — 82
Geely Emgrand X7. Manual part - 82
pressure test.
Standard Cylinder Pressure: 800 kPa
Are all cylinders compression pressure equal to or higher than the specified value?
14
Inspect timing chain positioning.
A. Turn off the ignition switch and remove the ignition key.
B. Refer to 2.6.8.11 "Timing Chain Inspection" to inspect timing chain positioning.
Is the chain positioned properly?
15
Install the timing chain.
A. Turn off the ignition switch and remove the ignition key.
B. Refer to the 2.6.8.10 "Replacement of Timing Chain Component" to reinstall the timing chain.
Start the engine, fault solved?
16
Inspect mechanical parts inside the engine.
A. Dismantle
the
engine.
B. Inspect engine mechanical parts. If necessary, repair the damaged engine components.
C. identify the engine damaged components repair has been completed.
17 Troubleshooting
Next
Yes
The system is normal.
No
Yes
Go to step 15
No
Yes
Go to step 15
No
327
2.2.7.58 Electronic Throttle Body (ETC) Self-adaptive Learn Program
Notes:
After the throttle body for cleaning and serving, carry out ETC self-adaptive learn. Otherwise
there will be idle instable, jitter and so on.
1
Use fault diagnosis tester "Action Test" function, clear the TPS learn value.
2
Turn the ignition switch to "ON" position, after 3 s to "OFF" position.
3
In 1s turn the ignition switch to "ON" position, after 3 s to "OFF" position.
4
Repeat the above steps 5 times.
5 Initialization
completed.
Next
Next
Next
Next
328
2.2.8 Removal and installation
2.2.8.1 Replacement of Engine Control Module
Dismantlement Procedure
Warning: Refer to Warning on
Battery Disconnection in Warnings
and Precautions.
1. Disconnect the battery negative
electrode cable. Refer to 2.12.6.1
Battery Disconnection.
2.
Refer to the 12.8.3.3
Replacement of Glove Box in
Complete Vehicle Maintenance
Manual to dismantle the glove
box of instrument panel.
3. Disconnect engine control
module harness connector .
GC02-0050c
4. Dismantle the fixing bolts of
engine control module.
GC02-1033c
Installation Procedure:
1. Install the fixing bolts of engine
control module.
Torque: 9Nm (Metric) 6.66 lb-ft
(English system)
2. Connect the engine control
module harness connector.
3. Install the glove box of
instrument panel.
4. Connect
battery
negative
cable.
GC02-1033c
329
2.2.8.2 Engine coolant temperature sensor
Dismantlement Procedure
Warning: Refer to Warning on
Battery Disconnection in Warnings
and Precautions.
1. Release pressure in the cooling
system.
2. Disconnect the battery negative
electrode cable. Refer to 2.12.6.1
Battery Disconnection.
3. Disconnect the temperature
sensor of engine coolant harness
connector.
4. Dismantle the temperature sensor
of engine coolant.
GC02-0031b
Installation Procedure:
1. Apply sealant on the temperature sensor of engine coolant thread.
2. Install the temperature sensor of engine coolant.
3. Connect temperature sensor of engine coolant harness connector.
4. Fill the engine coolant.
5. Connect battery negative cable.
330
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст