Geely Emgrand X7. Manual part — 281
Geely Emgrand X7. Manual part - 281
3.3.6 Dismantle and installation
3.3.6.1 Transmission oil level inspection
Inspection Procedure:
Note: Inspecting the transmission fluid when the
transmission fluid temperature is too high, it may
cause burns.
1. Park the vehicle on a level ground, wait for the
transmission fluid cooling down, Dismantle the
transmission fill plug and check the transmission
fluid level.
Note: Transmission fluid level should be even with
the lower edge of plug.
2. If the transmission fluid level is too low, add the
dedicated manual transmission fluid through the
plug to until the fluid begins to flow out.
3. Reinstall and tighten filling hole bolt
GC03-0025b
4. If needed, replace the transmission fluid.
Dismantle the transmission drain bolt, and drain
the transmission fluid.
GC03-0006c
1123
3.3.6.2 Vehicle speed sensor replacement
Warning: Refer to warning for battery disconnection in the warning and precaution.
Dismantle procedure
1. Disconnect the vehicle speed sensor harness
connector.
GC03-0027b
2. Dismantle the fixing bolt of speed sensor.
GC03-0007c
3. Dismantle the circlip as shown in the figure ,
disassemble the vehicle speed sensor driven gear.
GC03-0029b
1124
4. Disassembled
speed
sensor.
GC03-0030b
Installation procedure::
1. Install the vehicle speed sensor driven gear.
GC03-0031b
2. Install the driven gear clamp spring.
GC03-0032b
1125
3. Install the vehicle speed sensor and tighten the
fixing bolt, pay attention to the position of the
washer.
GC03-0007c
4. Connect the vehicle speed sensor harness
connector, as shown in the figure.
GC03-0034b
1126
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст