Geely Emgrand X7. Manual part — 462
Geely Emgrand X7. Manual part - 462
6. Remove the rear fixing bolt for the curtain airbag
and the curtain airbag.
NL09-0022b
Installation Procedure:
1. Install side air curtain.
2. Install and tighten fixing bolt on front of side air
curtain.
Torque : 9Nm (Metric) 6 . 7ft-bf(English system)
NL09-0020b
3. Install and tighten fixing bolt in the middle of air
curtain.
Torque: 9Nm (Metric) 6 . 7ft-bf(English system)
4. Install and tighten fixing bolt on the rear of side air
curtain.
5. Connect the harness connector of the curtain
airbag.
6. Install the in-vehicle roof trim panel.
7. Connect the battery negative cable.
NL09-0021b
1847
9.2.7.6 Driver waist airbag replacement (such as equipment)
Dismantlement Procedure
Warning: Refer to Warning on Battery
Disconnection in Warnings and Precautions.
1. Disconnect negative cable of battery and wait for
90s.
2. Dismantle fixing screw of left lower trimming
plate of instrument panel.
NL09-0024b
3. Dismantle driver's side knee airbag fixing bolt.
NL09-0025b
4. Disconnect driver's knee airbag wire harness
connector.
NL09-0026b
1848
Installation Procedure:
1. Connect to driver's knee airbag harness connector .
NL09-0026b
2. Install and tighten fixing bolt of driver knee
airbag.
Torque: 9 Nm (Metric) 6.7 lb-ft (English system)
NL09-0025b
3. Install and tighten fixing screw of left lower
trimming plate of instrument table.
Torque: 5 Nm (Metric) 3.7 lb-ft (English system)
NL09-0027b
1849
9.2.7.7 Front crash sensor replacement
Dismantlement Procedure
Warning: Refer to Warning on Battery
Disconnection in Warnings and Precautions.
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery Cable Disconnection and
Connection Procedures.
2. Disconnect front impact sensor wire harness
connector.
3. Dismantle fixing bolt of front impact sensor and
take of left front impact sensor.
NL09-0028b
Installation Procedure:
1. Install and tighten front impact sensor fixing
sensor fixing bolt.
Torque: 8Nm (Metric system) 5.9lb-ft (English system)
2. Connect front impact sensor wire harness
connector.
3. Connect the battery negative cable.
NL09-0028b
1850
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст