Geely EC718, EC718RV, EC715, EC715RV. Manual part — 545
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 545
FE12-1058b
7.
Sand the surface with a piece of 2000# fine sanding paper
and expand the polishing area.
FE12-1059b
8.
After finish polishing, remove the dust with a cloth to
prepare for painting work.
FE12-1060
9.
Spray the background color paint.
Air pressure 150-200 kPa (21.8-29.0 psi)
Spray distance 20-30 cm (7.87-11.81 in)
Note
Spray a layer slightly wider than the previous layer
in order to make the transition.
Body, Sheet Metal and Painting
Paint/Coatings
12-169
FE12-1060b
10. Leave the surface dry 2-3 min before spray the second
layer of background paint until the layer joints become
insignificant.
Air Pressure 150-200 kPa (21.8-29.0 psi)
Spray Distance 20-30 cm (7.87-11.81 in)
FE12-1062b
11. Leave the surface dry 4-5 min and then heat to dry 20-30
min.
Paint room temperature 70-80 at 70-80°C (158-176 ºF)
FE12-1063b
12. After drying, remove the dust with a cloth to prepare for
painting work.
12-170
Paint/Coatings
Body, Sheet Metal and Painting
FE12-1064b
13. Spray clear lacquer to cover the whole background
painting area.
Air Pressure 150-200 kPa (21.8-29.0 psi)
Spray Distance 20-30 cm (7.87-11.81 in)
FE12-1065b
14. Leave the surface dry 2-3min and then spray paint the
second layer of clear lacquer to cover the area of the first
layer of clear lacquer.
Air Pressure 150-200 kPa (21.8-29.0 psi)
Spray Distance 20-30 cm (7.87-11.81 in)
FE12-1066b
15. After spraying the clear lacquer, add blending thinner or
other additives to the original clear lacquer.
Body, Sheet Metal and Painting
Paint/Coatings
12-171
FE12-1067b
16. Spray the paint interface 2-3 times with the blending
thinner or the diluted clear lacquer.
FE12-0068b
17. Dry the paint in the paint room 20-30 min.
Paint room temperature 70-80°C (158-176 ºF)
12.13.4.5 Spray Paint on the Repaired Rigid
Sheet Metal Surface Procedure
Spray paint on the repaired rigid sheet metal surface process
is similar to spray paint on the sheet metal surface. There are
only a few additional steps between grinding and spray paint
background as following:
1. Apply Putty.
2. Putty grinding.
3. Removing dust, de-greasing, cleaning.
4. Filling Scratch gray eyes filled.
5. Sanding the old paint surface.
6. Cleaning, de-greasing and covering adjacent areas.
For the painting process, please refer to
12-172
Paint/Coatings
Body, Sheet Metal and Painting
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст