Geely EC718, EC718RV, EC715, EC715RV. Manual part — 418
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 418
FE11-0303b
4.
Remove the front door inside handle retaining screw
cover.
FE11-0304b
5.
Remove the front door trim panel retaining screw.
Note
There are two retaining screws at the lower side of
the front door trim panel.
FE11-0305b
6.
Remove the front door trim panel.
Note
Do not to damage the the wiring harness connectors
inside the front door trim panel.
Body Electric
Glasses / Windows / Mirrors
11-185
FE11-0306b
7.
Disconnect the front tweeter harness connector.
FE11-0307b
8.
Disconnect the front window switch harness connector
and remove the front door trim panel.
FE11-0308b
9.
Disconnect outside rearview mirror harness connector,
loose the outside rearview mirror bracket nut.
10. Leave the nut on the top and remove the other two
rearview mirror bracket nuts.
11. Hold the outside rearview mirror and remove the
remaining nut.
11-186
Glasses / Windows / Mirrors
Body Electric
12. Remove the outside rearview mirror assembly.
Installation Procedure:
1.
Install the outside rearview mirror assembly and tighten
the retaining nuts.
Torque: 6 Nm (Metric) 4.4 lb-ft (US English)
Note
"Fastener Notice" in "Warnings and Notices"
2.
Connect the outside rearview mirror harness connector.
FE11-0311b
3.
Connect the front window switch wiring harness
connector.
Body Electric
Glasses / Windows / Mirrors
11-187
FE11-0312b
4.
Connect the front tweeter harness connector.
5.
Install the new clips to the front door trim panel.
6.
Install the front door trim panel.
Torque: 2 Nm (Metric) 1.5 lb-ft (US English)
7.
Install the front door armrest retaining screw cover.
Torque: 2 Nm (Metric) 1.5 lb-ft (US English)
8.
Install the front door handle retaining screw cover.
9.
Install the front door triangular panel.
10. Connect the battery negative cable.
11.5.8.2 Inside Rearview Mirror Replacement
Removal Procedure
FE11-0313b
1.
Remove the inside rearview mirror from the retaining
bracket.
2.
Remove the inside rearview mirror bracket.
Note
The inside rearview mirror is bonded to the
windshield using a special adhesive.
Installation Procedure:
FE11-0314b
1.
Use dedicated cleaning agent to clean the inside rearview
mirror bracket installation surface.
2.
Apply the adhesive according to the adhesive
requirements.
3.
Position the inside rearview mirror bracket to the marked
position, with the constant pressure to press the bracket
on the glass for 1-2 min.
4.
Use dedicated cleaning agent to remove excess adhesive
after 5 min.
11-188
Glasses / Windows / Mirrors
Body Electric
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст