Geely EC718, EC718RV, EC715, EC715RV. Manual part — 315
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 315
Next
Step 9
System normal.
Brake System
ABS / TCS / EBD / ESP
6-93
6.6.7 Removal and Installation
6.6.7.1 Hydraulic Electronic Control Unit
Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices" .
FE06-0086b
1.
Disconnect the battery negative cable. Refer to
.
2.
Remove the air filter and air filter to the throttle pipe.
3.
Press plug, pull the zipper upward, disconnect the brake
regulator wiring harness connector.
4.
Drain the brake fluid.
5.
Use a cloth to cover the wiring harness connector sockets
and plugs to avoid contact with brake fluid.
Note
Refer to "Brake Fluid Effects on Paint and Electrical
Components Notice" in "Warnings and Notices".
FE06-0087b
6.
Remove brake fluid pipe connecting nuts from the brake
adjuster, and immediately wipe the brake fluid overflow.
6-94
ABS / TCS / EBD / ESP
Brake System
4
3
5
6
2
1
FE06-0088b
7.
Use tags or make marks to identify the locations for re-
connection.
Tip:
1. To the No. 1 Brake Master Cylinder
2. To the No. 2 Brake Master Cylinder
3. To the Right Front Brake Cylinder
4. To the Left Rear Brake Cylinder
5. To the Right Rear Brake Cylinder
6. To the Left Front Brake Cylinder
FE06-0089b
8.
Lift and support the vehicle. Refer to
.
9.
Remove the engine bottom shield. Refer to
and Right Engine Bottom Shield Replacement
.
10. Remove the brake adjuster bracket retaining bolts.
11. Remove the hydraulic electronic control unit.
Installation Procedure:
FE06-0090b
1.
Install the hydraulic electronic control unit and tighten the
bolts.
Torque: 25 Nm (Metric) 18.5 lb-ft (US English)
Brake System
ABS / TCS / EBD / ESP
6-95
FE06-0091b
2.
Install the brake hard pipe joints, and tighten the nuts.
Torque: 16 Nm (Metric) 11.9 lb-ft (US English)
FE06-0092b
3.
Push down the lock, connect the hydraulic electronic
control unit wiring harness connector.
4.
Fill the brake fluid.
Note
Refer to "Adding Fluid to the Brake System Notice"
in "Warnings and Notices".
5.
Discharge air from the hydraulic brake system.
6.
Check whether the brake system is leaking.
7.
Install the engine bottom shield.
8.
Connect the battery negative cable.
6.6.7.2 Wheel Speed Sensor Replacement
(Front)
Removal Procedure:
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices" .
6-96
ABS / TCS / EBD / ESP
Brake System
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст