Geely EC718, EC718RV, EC715, EC715RV. Manual part — 127
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 127
FE02-0288b
6.
Rotate the crank a circle (360 °), enable the cylinder No.
4 is at TDC position, measure the clearance as arrow
pointed in the graphic and record the clearance.
FE02-0289b
7.
Use a jack to support the engine. Remove the timing
chain. Refer to
.
8.
Remove the camshaft. Refer to
9.
Remove the valve lifter that exceeds the tolerances. Use
outside diameter micrometer to measure the thickness,
according to the following formula calculate the thickness
of the new valve lifters.
Intake: A=B + C - 0.23 mm (0.01 in)
Exhaust: A=B + C - 0.32 mm (0.13 in)
A
New Valve Lifter Thickness
B
Old Valve Lifter Thickness
C
Measured Valve Clearance
10. Selected new valve lifters must be as close as possible to
the calculated values. For specifications. Refer to the
thickness of the valve lifter
Valves Lifter Specifications Table
.
11. Based on the measurement, according to
and Exhaust Valves Lifter Selection Table
, choose the
valve lifter to meet the specifications .
12. Install intake and exhaust camshafts.
13. Install the timing chain.
14. Install the timing chain cover.
15. Install the ignition coil.
16. Install the engine plastic shield.
Engine
Engine Mechanical System JL4G18-D
2-423
2.6.8.21
Crankshaft
Front
Oil
Seal
Replacement
Removal Procedure:
FE02-0152b
1.
Remove the crankshaft belt plate. Refer to
2.
Remove the crankshaft front oil seals.
Note
Be careful not to damage the crankshaft journal.
Installation Procedure:
FE02-0501b
1.
Use a special tool GL301-013 to install the crankshaft
front oil seals.
2.
Install the crankshaft belt plate.
2-424
Engine Mechanical System JL4G18-D
Engine
2.6.8.22
Crankshaft
Rear
Oil
Seal
Replacement
Removal Procedure:
FE02-0503b
1.
Remove the flywheel. Refer to
2.
Remove the crankshaft rear oil seals.
Note
Be careful not to damage the crankshaft journal.
Installation Procedure:
FE02-0504b
1.
Use a special tool GL301-015 to install the crankcase rear
oil seals.
2.
Install the flywheel.
Engine
Engine Mechanical System JL4G18-D
2-425
2.6.9 Special Tools and Equipment
2.6.9.1 Special Tools List
Serial
Number
Illustration
Tool Number
Description
1
FE01-2014b
GT301-002
Seal Handle
2
FE01-2015b
GT301-006
Valve Oil Seal Removal Tool
3
FE01-2016b
GT301-008
Valve Seal Installation Tool
4
FE01-2017b
GT301-009
Valve Guide Removal Tool
2-426
Engine Mechanical System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст