Geely EC718, EC718RV, EC715, EC715RV. Manual part — 130
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 130
2.7.4.4 Rear Muffler Assembly
FE02-2033b
Engine
Exhaust System JL4G18-D
2-435
2.7.4.5 Front Exhaust Insulation Panel
FE02-2078b
2-436
Exhaust System JL4G18-D
Engine
2.7.4.6 Front Muffler Heat Shield
FE02-2034b
Engine
Exhaust System JL4G18-D
2-437
2.7.5 Diagnostic Information and Procedures
2.7.5.1 Diagnostic Description
Refer to "Description and Operation" in the
Get familiar with the system functions and operation before start
system diagnostics, as this will help with the correct diagnostic steps, more importantly, it will also help to determine whether the
customer described situation is normal.
2.7.5.2 Visual Inspection
–
Check installed after market equipment that may affect the operation of the exhaust system.
–
Check the easy to access system components to identify whether there are significant blockages or leakage.
–
Check whether the color of the exhaust gas is normal.
2.7.5.3 Exhaust System Blockage
When the engine loses power, fuel economy becomes worse or acceleration performance is poor, check whether there is "exhaust
system blockage" fault, use the exhaust back-pressure to monitor whether the back-pressure is more than 50 kPa to confirm the
fault. The fault may be caused by following reasons:
–
Exhaust pipe is damaged.
–
There are debris in exhaust pipes.
–
Muffler or resonator internal faults.
–
Exhaust pipe internal corrosion blocks the rear exhaust port.
2.7.5.4 Exhaust System Leakage
If the engine has "hiss" or a burst sound sound when running, check whether there is "Exhaust System Leakage" fault, as shown in
the following table:
Exhaust system components misaligned or incorrectly installed
–
Position and tighten the exhaust system components to the
specified torque. Refer to "Engine Exhaust System" in
the
Fastener Tightening Specifications
.
–
Make sure that the exhaust pipe hook is in the right place and
is not loose.
Exhaust leak at the following connections:
–
Exhaust manifold and the three-way catalytic converter
–
Flange
Tighten the related components to the specified torque. Refer to
the "Engine Exhaust System" in the
Seal or Gasket Leak:
–
Exhaust Manifold and Cylinder Head Cover
–
Exhaust Manifold and The Three-Way Catalytic Converter
–
Three-Way Catalytic Converter and Front Muffler
–
Front Muffler and Rear Muffler
Replace the leaking seals or gasket.
2-438
Exhaust System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст