Двигатели Scania четвёртой серии. Руководство — часть 157
66
ã
03:04-06
Fault code D002
Fault
Internal fault in the control unit.
Cause
The control unit could not process (convert) the
signal from the fuel supply pressure sensor.
Remarks
If the fault is active, the control unit uses a pre-
programmed value (21,4 bar absolute
pressure).
Engine torque is limited by 30% as long as the
fault is active.
Action
Clear the fault code memory. Start the engine
and accelerate the engine to full speed.
If the fault code is regenerated, renew the
control unit.
Fault codes
03:04-06
ã
67
Fault code D004
Fault
The control unit does not rely on the fuel
supply pressure sensor signal even though it is
within the electrical tolerances.
Cause
The supply pressure is implausibly high in
comparison with normal pressure for different
operational conditions.
Remarks
If the voltage is outside the permitted range, the
control unit uses a pre-programmed value
(21,4 bar absolute pressure).
Engine torque is limited by approximately 30%
as long as the fault is active.
Action
Check the overflow valve.
Check the signal from the fuel feed pressure
sensor.
Check for any visible faults on the sensor and
the wiring.
Clean the connectors.
Then, erase the fault code memory and check
whether the fault code is generated again.
Fault codes
68
ã
03:04-06
Fault code D005
Fault
The control unit does not rely on the fuel
supply pressure sensor signal even though it is
within the electrical tolerances.
Cause
The supply pressure is implausibly low in
comparison with normal pressure for different
operational conditions.
Remarks
If the voltage is outside the permitted range, the
control unit uses a pre-programmed value
(21,4 bar absolute pressure).
Engine torque is limited by approximately 30%
as long as the fault is active.
Action
Check the signal from the fuel supply pressure
sensor.
Check for any visible faults on the sensor and
the wiring.
Clean the connectors.
Then, erase the fault code memory and check
whether the fault code is generated again.
The fault may also be due to any of the
following causes:
One of the two overflow valves opens too early.
The fuel shut-off valve is closed.
The fuel filter is blocked.
Air in the fuel or out of fuel.
Defect supply pump.
Serious leakage in the fuel system.
Fault codes
03:04-06
ã
69
Fault code D100
Fault
The voltage has been above 4.79 V (above
20.3 bar absolute pressure), i.e. above the upper
limit for the fuel pressure to the front bank,
cylinder 1-3.
Cause
The voltage between pin 3 and 2 in connector
A1 is too high, or there is a fault with the
voltage supply to sensor group 2 (pin 8 in
connector B2, pin 1 in connector A1).
Remarks
If the voltage is outside the permitted range, the
control unit uses a pre-programmed value
(0.448 bar absolute pressure).
If the value from the fuel pressure sensor for
the rear bank, cylinder 4-6 is incorrect at the
same time, it is probably the shared voltage
supply for the sensors which is faulty.
Engine torque is limited by 30% as long as the
fault is active.
Action
Check the signal from the fuel pressure sensor.
Check for any visible faults on the sensor and
the wiring.
Clean the connectors.
Then, erase the fault code memory and check
whether the fault code is generated again.
Fault codes
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст