Двигатели Scania четвёртой серии. Руководство — часть 165
98
ã
03:04-06
Fault code D804
Fault
Internal fault in the control unit.
Cause
The voltage on several driver stages is too low.
Remarks
As a result, the engine will probably run
unevenly. The engine torque is reduced by
30%.
Action
Clear the fault code memory. Start the engine
and accelerate the engine to full speed.
Check if the fault code has been generated
again. If the fault code has been regenerated,
renew the control unit.
Fault codes
03:04-06
ã
99
Fault code D900
Fault
The voltage has been above 4.90 V (below -
40°C), i.e. the fuel temperature was below its
lower limit.
Cause
The voltage between pins 3 and 10 in connector
B2 is too high.
Remarks
If the voltage is outside the permitted range, the
control unit uses a pre-programmed
temperature value (40°C).
Action
Check the signal from the fuel temperature
sensor.
Measure the resistance of the fuel temperature
sensor.
Check for any visible faults on the fuel
temperature sensor, the connectors and the
wiring.
Then, erase the fault code memory and check
whether the fault code is generated again.
Fault codes
100
ã
03:04-06
Fault code D901
Fault
The voltage has been below 0.440 V (above
130°C), i.e.the fuel temperature was above its
upper limit.
Cause
The voltage between pins 3 and 10 in connector
B2 is too high.
Remarks
If the voltage is outside the permitted range, the
control unit uses a pre-programmed
temperature value (40°C).
Action
Check the signal from the fuel temperature
sensor.
Measure the resistance of the fuel temperature
sensor.
Check for any visible faults on the fuel
temperature sensor, the connectors and the
wiring.
Then, erase the fault code memory and check
whether the fault code is generated again.
Fault code D902
Fault
Internal fault in the control unit.
Cause
The control unit has not been able to process
(convert) the signal from the fuel temperature
sensor.
Remarks
If the voltage is outside the permitted range, the
control unit uses a pre-programmed
temperature value (40°C).
Action
Clear the fault code memory. Start the engine
and accelerate the engine to full speed.
If the fault code is regenerated, renew the
control unit.
Fault codes
03:04-06
ã
101
Fault code E000
Fault
Internal fault in the control unit.
Cause
The control unit supplies the fuel volume
solenoid valve on the front bank, cylinder 1-3,
with an incorrect activation time.
Remarks
The fuel injection (the engine) is switched off
as long as the fault is active.
As a result, the fault may also generate other
fault codes.
Action
Clear the fault code and drive the vehicle for
approximately 10 minutes. Check if the fault
code has been generated again.
If the fault code has been regenerated, renew
the control unit.
Fault code E001
Fault
Internal fault in the control unit.
Cause
The control unit supplies the fuel volume
solenoid valve on the rear bank, cylinder 4-6,
with an incorrect activation time.
Remarks
The fuel injection (the engine) is switched off
as long as the fault is active.
As a result, the fault may also generate other
fault codes.
Action
Clear the fault code and drive the vehicle for
approximately 10 minutes. Check if the fault
code has been generated again.
If the fault code has been regenerated, renew
the control unit.
Fault codes
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст