Lexus GS300/400 (2000 year). Manual — part 252
RS07Y–01
H02696
H02697
RS–62
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT AIRBAG SENSOR
2293
INSTALLATION
1.
INSTALL FRONT AIRBAG SENSOR
Install the sensor with bolt and nut, then connect the connector.
Torque: 7.8 N·m (80 kgf·cm, 69 in.·lbf)
NOTICE:
Make sure the sensor is installed to the specified
torque.
If the sensor has been dropped, or there are cracks,
dents or other defects in the case, brackets or con-
nector, replace the removed sensor. Always replace
the set bolt and nut with new ones.
The sensor set bolt and nut have been anti–rust
treated. When the sensor is removed, always replace
the set bolt and nut with new ones.
After installation, shake the sensor to check that
there is no looseness.
The front sensor is equipped with an electrical con-
nection check mechanism. Be sure to lock this mech-
anism securely when connecting the connector. If the
connector is not securely locked, a malfunction code
will be detected by the diagnostic system.
2.
INSTALL REMOVED PARTS
RS07Z–01
H02617
Center Pillar Lower Garnish
Front Door Scuff Plate
Rear Door Scuff Plate
Side Airbag
Sensor Assembly
Front Seat
Outer Belt Retractor
41 (420, 30)
7.4 (75, 65 in.·lbf)
20 (200, 14)
: Specified torque
N·m (kgf·cm, ft·lbf)
–
SUPPLEMENTAL RESTRAINT SYSTEM
SIDE AIRBAG SENSOR ASSEMBLY
RS–63
2294
SIDE AIRBAG SENSOR ASSEMBLY
COMPONENTS
RS080–01
H02619
H02620
RS–64
–
SUPPLEMENTAL RESTRAINT SYSTEM
SIDE AIRBAG SENSOR ASSEMBLY
2295
REMOVAL
NOTICE:
Do not open the cover or the case of the ECU and various
computers unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by
static electricity.)
1.
REMOVE THESE PARTS:
(a)
Front door scuff plate
(b)
Rear door scuff plate
(c)
Center pillar lower garnish
2.
REMOVE FRONT SEAT OUTER BELT RETRACTOR
(See page
)
(a)
w/ Seat Belt Pretensioner:
Disconnect the pretensioner connector.
(b)
w/ Seat Belt Warning:
Disconnect the retractor switch connector.
(c)
Remove the 2 bolts and retractor.
3.
REMOVE SIDE AIRBAG SENSOR ASSEMBLY
(a)
Disconnect the connector.
NOTICE:
Remove the connector with the sensor assembly installed.
(b)
Using a torx wrench, remove the 4 screws and side airbag
sensor assembly.
Torx wrench: T40 (Part No.09042–00020 or locally
manufactured tool)
RS081–01
H02576
–
SUPPLEMENTAL RESTRAINT SYSTEM
SIDE AIRBAG SENSOR ASSEMBLY
RS–65
2296
INSPECTION
1.
VEHICLES NOT INVOLVED IN COLLISION
Do a diagnostic system check.
(See page
2.
VEHICLE INVOLVED IN COLLISION AND AIRBAG IS
NOT DEPLOYED
Do a diagnostic system check.
(See page
3.
VEHICLE INVOLVED IN COLLISION AND AIRBAG IS
DEPLOYED
Replace the airbag sensor assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст