Lexus GS300/400 (2000 year). Manual — part 115
CH044–01
B01996
Generator Wire
Pipe Clamp
A/T Oil Cooler Pipe
Pipe Bracket
Generator Connector
Generator
Engine Under Cover
x 18
Drive Belt
CH–4
–
CHARGING (2JZ–GE)
GENERATOR
1606
GENERATOR
COMPONENTS
B01642
Pulley
Rotor
Rectifier End Frame
Drive End Frame (Stator)
Bearing Cover
(Inside)
Generator
Washer
Brush Holder Cover
Bearing Retainer
Terminal Insulator
Seal Plate
Rubber Insulator
Rear End Cover
Plate Terminal
Bearing Cover
Rectifier Holder
Brush Holder
Rear Bearing
Front Bearing
Wire Clip
Voltage Regulator
Non–reusable part
–
CHARGING (2JZ–GE)
GENERATOR
CH–5
1607
CH045–01
B02027
Turn
B01646
B01962
Engine
Wire Clamp
Pipe Clamp
B01963
Pipe Bracket
CH–6
–
CHARGING (2JZ–GE)
GENERATOR
1608
REMOVAL
1.
REMOVE ENGINE UNDER COVER
2.
REMOVE DRIVE BELT
Loosen the belt tension by turning the drive belt tensioner clock-
wise, and remove the drive belt.
NOTICE:
At the time of installation, please refer to the following
items. Do an on–vehicle inspection. (See page
)
3.
REMOVE GENERATOR
(a)
Disconnect the generator connector.
(b)
Remove the rubber cap and nut, and disconnect the gen-
erator wire.
(c)
Disconnect the engine wire clamp from the wire clip on the
generator.
(d)
Remove the bolt and pipe clamp, and disconnect the 2
A/T oil cooler pipes from the generator.
(e)
Remove the bolt, nut, pipe bracket and generator.
Torque: 40 N·m (400 kgf·cm, 30 ft·lbf)
B01655
CH046–05
B01654
Plate Terminal
B01997
B01650
P10835
Turn
SST (B)
SST (A)
–
CHARGING (2JZ–GE)
GENERATOR
CH–7
1609
DISASSEMBLY
1.
REMOVE REAR END COVER
(a)
Remove the nut and terminal insulator.
(b)
Remove the bolt, 3 nuts, plate terminal and end cover.
2.
REMOVE BRUSH HOLDER AND VOLTAGE REGULA-
TOR
(a)
Remove the brush holder cover from the brush holder.
(b)
Remove the 5 screws, brush holder and voltage regulator.
(c)
Remove the seal plate from the rectifier end frame.
3.
REMOVE RECTIFIER HOLDER
(a)
Remove the 4 screws and rectifier holder.
(b)
Remove the 4 rubber insulators.
4.
REMOVE PULLEY
(a)
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST
09820–63010
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
(b)
Check that SST (A) is secured to the rotor shaft.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст