Lexus GS300/400 (2000 year). Manual — part 10
I05295
Stator
Rotor
Shim
Pressure Plate
Snap Ring
Compressor
Snap Ring
13.2 (135, 9)
N·m (kgf·cm, ft·lbf) : Specified torque
Non–reusable part
–
AIR CONDITIONING
COMPRESSOR AND MAGNETIC CLUTCH
AC–37
2722
AC0WV–01
I02381
I02380
I02382
AC–38
–
AIR CONDITIONING
COMPRESSOR AND MAGNETIC CLUTCH
2723
REMOVAL
1.
RUN ENGINE AT IDLE SPEED WITH A/C ON FOR
APPROX. 10 MINUTES
2.
STOP ENGINE
3.
DISCONNECT NEGATIVE (–) TERMINAL CABLE
FROM BATTERY
4.
DISCHARGE REFRIGERANT FROM REFRIGERATION
SYSTEM
5.
REMOVE ENGINE UNDER COVER
6.
REMOVE DRIVE BELT
(See page
7.
GS400:
DISCONNECT DISCHARGE HOSE
Remove the nut and disconnect the discharge hose.
NOTICE:
Cap the open fitting immediately to keep moisture or dirt
out of the system.
8.
GS400:
REMOVE SUCTION HOSE
Remove the nut, bolt and suction hose.
NOTICE:
Cap the open fitting immediately to keep moisture or dirt
out of the system.
9.
GS300:
DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the 2 nut and disconnect the both hoses.
NOTICE:
Cap the open fitting immediately to keep moisture or dirt
out of the system.
N08002
I02384
I02385
I02386
I02383
–
AIR CONDITIONING
COMPRESSOR AND MAGNETIC CLUTCH
AC–39
2724
10.
GS300:
REMOVE 2 PS PUMP SET BOLTS
11.
GS300:
REMOVE COMPRESSOR
(a)
Remove the bolt and PS pump bracket.
(b)
Remove the 2 bolts and compressor bracket.
(c)
Disconnect the connector.
(d)
Remove the nut and 3 bolts.
(e)
Using a torx socket (E10), remove the stud bolt and com-
pressor.
12.
GS400:
REMOVE COMPRESSOR
(a)
Disconnect the connector.
(b)
Remove the nut, bolt and compressor stay.
(c)
Remove the 2 bolts and compressor.
AC0WW–01
AC0943
SST
AC0944
SST
AC0945
SST
AC0946
Shim
Pressure
Plate
AC0947
SST
AC–40
–
AIR CONDITIONING
COMPRESSOR AND MAGNETIC CLUTCH
2725
DISASSEMBLY
1.
REMOVE PRESSURE PLATE
(a)
Using SST and a socket wrench, remove the shaft bolt.
SST
07112–76060
Torque: 13.2 N·m (135 kgf·cm, 9 ft·lbf)
(b)
Install SST on the pressure plate.
SST
07112–66040
(c)
Using SST and socket wrench, remove the pressure
plate.
SST
07112–66040, 07112–76060
(d)
Remove the shims from the pressure plate.
2.
REMOVE ROTOR
(a)
Using SST, remove the snap ring.
SST
07114–84020
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст