Lexus RX300 (MCU15). Manual — part 567
D03902
D03557
D03903
D03558
D03904
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
AX–11
U140F AX (RM848E)
(c)
Remove the O–ring from the piston.
(d)
Apply compressed air (392 kPa, 4.0 kgf/cm
2
, 57 psi) to the
oil hole and remove the C
1
accumulator piston and spring.
NOTICE:
S
Blowing off the air may cause the piston’s jump–out.
When removing the piston, hold it with your hand us-
ing a waste cloth.
S
Take care not to splash ATF when air–blowing.
(e)
Remove the 2 O–rings from the piston.
(f)
Apply compressed air (392 kPa, 4.0 kgf/cm
2
, 57 psi) to the
oil hole and remove the B
3
accumulator piston and 2
springs.
NOTICE:
S
Blowing off the air may cause the piston’s jump–out.
When removing the piston, hold it with your hand us-
ing a waste cloth.
S
Take care not to splash ATF when air–blowing.
(g)
Remove the O–ring from the piston.
D03559
D03560
D03561
D03563
D03564
AX–12
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
U140F AX (RM848E)
17.
REMOVE MANUAL VALVE LEVER SHAFT
(a)
Using needle–nose pliers, remove the retainer spring.
(b)
Remove the 2 bolts, manual detent spring and cover.
(c)
Remove the 2 bolts and parking lock pawl bracket.
(d)
Using a chisel and hammer, unstake and remove the
spacer.
(e)
Using a pin punch and hammer, drive out the pin.
HINT:
Slowly drive out the pin so that it will not fall into the transaxle
case.
D03565
D03905
D03566
D03567
D03568
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
AX–13
U140F AX (RM848E)
(f)
Remove the manual valve lever shaft and manual valve
lever.
(g)
Remove the parking lock rod from the manual valve lever
shaft.
(h)
Using a screwdriver, remove the oil seal.
18.
PLACE TRANSAXLE CASE
Fix the transaxle case with the oil pump side facing up.
19.
INSPECT INPUT SHAFT END PLAY
Using a dial indicator, measure the input shaft end play.
End play: 0.27 – 1.24 mm (0.0106 – 0.0488 in.)
20.
REMOVE TRANSAXLE HOUSING
(a)
Remove the 16 bolts.
(b)
Tap on the circumference of the transaxle housing with a
plastic hammer to remove the transaxle housing from the
transaxle case.
NOTICE:
Differential may be accidentally removed when the trans-
axle housing is removed.
D03569
D03570
D03571
D03572
D03573
AX–14
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
U140F AX (RM848E)
21.
REMOVE OIL PUMP
(a)
Remove the 7 bolts and oil pump.
(b)
Remove the O–ring from the oil pump.
22.
REMOVE THRUST BEARING AND BEARING RACE
Remove the thrust bearing and bearing race from the U/D plan-
etary gear assembly.
23.
REMOVE DIFFERENTIAL ASSEMBLY
24.
REMOVE 2 APPLY GASKETS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст