Lexus RX300 (MCU15). Manual — part 529
RS0JW–07
H05115
N·m (kgf·cm, ft·lbf) : Specified torque
Front Passenger Airbag Assembly
20 (205, 15)
Lower Finish Panel
5.6 (57, 50 in.·lbf)
5.6 (57, 50 in.·lbf)
Lower No. 2 Panel
CD Changer
RS–26
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
LEXUS RX300 (RM785E)
FRONT PASSENGER AIRBAG ASSEMBLY
COMPONENTS
RS0JX–03
H05116
H05117
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
RS–27
LEXUS RX300 (RM785E)
REMOVAL
NOTICE:
S
If the wiring connector of the SRS is disconnected
and the ignition switch is in ON position, DTCs will be
recorded.
S
Never use the airbag parts from another vehicle.
When replacing parts, replace them with new parts.
1.
DISCONNECT AIRBAG CONNECTOR
(a)
Using a screwdriver, pry out the glove compartment door
finish plate inside the lower No. 2 panel.
HINT:
Tape the screwdriver tip before use.
(b)
Remove the connector from the glove compartment door
finish plate.
(c)
Disconnect the airbag connector.
NOTICE:
When disconnecting the airbag connector, take care not to
damage the airbag wire harness.
2.
REMOVE LOWER NO. 2 PANEL
(a)
Remove the front door scuff plate RH and cowl side trim
RH.
(b)
Remove the No. 2 under cover.
(c)
Remove the 2 bolts, 2 screws and lower No. 2 panel.
(d)
w/ CD changer:
Remove the 4 nuts and CD changer.
3.
REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
(a)
Remove the 2 bolts and 2 nuts.
(b)
Remove the front passenger airbag assembly from the
instrument panel.
CAUTION:
S
Do not store the front passenger airbag assembly
with the airbag deployment side facing down.
S
Never disassemble the front passenger airbag as-
sembly.
RS0JY–05
H05057
H05118
H05119
RS–28
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
LEXUS RX300 (RM785E)
INSPECTION
1.
Vehicles not involved in collision:
INSPECT SUPPLEMENTAL RESTRAINT SYSTEM
(a)
Do a diagnostic system check (See page DI–305).
(b)
Do a visual check which includes the following item with
the front passenger airbag assembly installed in the ve-
hicle.
Check cuts, minute cracks or marked discoloration on the
front passenger airbag assembly and instrument panel.
2.
Vehicle involved in a collision and airbag is not
deployed:
INSPECT SUPPLEMENTAL RESTRAINT SYSTEM
(a)
Do a diagnostic system check (See page DI–305).
(b)
Do a visual check which includes the following items with
the front passenger airbag assembly removed from the
vehicle.
S
Check cuts, minute cracks or marked discoloration
on the front passenger airbag assembly.
S
Check cuts and cracks in wire harness, and for chip-
ping in connectors.
S
Check the deformation or cracks on the instrument
panel and instrument panel reinforcement.
CAUTION:
For removal and installation of the front passenger airbag
assembly, see page RS–27 and RS–37, and be sure to fol-
low the correct procedure.
HINT:
If the instrument panel or instrument panel reinforcement is de-
formed or cracked, never repair it. Always replace it with a new
one.
H05120
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
RS–29
LEXUS RX300 (RM785E)
3.
Vehicle involved in a collision and airbag is deployed:
INSPECT SUPPLEMENTAL RESTRAINT SYSTEM
(a)
Do a diagnostic system check (See page DI–305).
(b)
Do a visual check which includes the following items with
the front passenger airbag assembly removed from the
vehicle.
S
Check the deformation or cracks on the instrument
panel and instrument panel reinforcement.
S
Check the damage on the connector and wire har-
ness.
CAUTION:
For removal and installation of the front passenger airbag
assembly, see page RS–27 and RS–37, and be sure to fol-
low the correct procedure.
HINT:
If the instrument panel or instrument panel reinforcement is de-
formed or cracked, never repair it. Always replace it with a new
one.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст