Lexus RX300 (MCU15). Manual — part 96
AC1N5–01
AC–52
–
AIR CONDITIONING
CONDENSER
LEXUS RX300 (RM785E)
CONDENSER
ON–VEHICLE INSPECTION
1.
INSPECT CONDENSER FINS FOR BLOCKAGE OR DAMAGE
If the fins are clogged, wash them with water and dry with compressed air.
NOTICE:
Be careful not to damage the fins.
If the fins are bent, straighten them with a screwdriver or pliers.
2.
INSPECT CONDENSER AND FITTING FOR LEAKAGE
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
AC3AS–01
I20936
Condenser
Discharge Hose
z O–Ring
z O–Ring
Liquid Tube
Radiator Upper Seal
Front Bumper Cover
Engine Under Cover
10 (100, 7)
10 (100, 7)
N·m (kgf·cm, ft·lbf) : Specified toque
z Non–reusable part
–
AIR CONDITIONING
CONDENSER
AC–53
LEXUS RX300 (RM785E)
COMPONENTS
I18293
Condenser
12.3 (125, 9)
Dryer
Filter
Cap
N·m (kgf·cm, ft·lbf) : Specified torque
Compressor oil ND–OIL 8 or equivalent
AC–54
–
AIR CONDITIONING
CONDENSER
LEXUS RX300 (RM785E)
AC1N7–01
I06849
I06874
I06852
–
AIR CONDITIONING
CONDENSER
AC–55
LEXUS RX300 (RM785E)
REMOVAL
1.
DISCHARGE REFRIGERANT FROM REFRIGERATION
SYSTEM
HINT:
At the time of installation, please refer to the following item.
Evacuate air from refrigeration system.
Charge system with refrigerant and inspect for leakage of refrig-
erant.
Specified amount : 650 ± 50 g (22.92 ± 1.76 oz.)
2.
REMOVE RADIATOR UPPER SEAL
Remove the 7 clips and radiator upper seal.
3.
REMOVE FRONT BUMPER
(See page BO–4)
4.
DISCONNECT DISCHARGE HOSE AND LIQUID TUBE
Remove the 2 bolts and disconnect the hose and tube.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
NOTICE:
Cap the open fittings immediately to keep moisture or dirt
out of the system.
HINT:
At the time of installation, please refer to the following item.
Lubricate 2 new O–rings with compressor oil and install them
to the hose and tube.
5.
REMOVE CONDENSER
(a)
Disconnect the liquid tube piping clamp.
(b)
Remove the 2 bolts and pull out the condenser upward.
HINT:
At the time of installation, please refer to the following item.
If condenser is replaced, add compressor oil to the condenser.
Add 40 cc (1.4 fl. oz)
Compressor oil: ND – OIL 8 or equivalent
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст