Lexus RX300 (MCU15). Manual — part 120
I04265
N20125
1
2
OFF
ON
N21361
Wire Harness Side
1
2
–
BODY ELECTRICAL
IGNITION SWITCH AND KEY UNLOCK WARNING
SWITCH
BE–27
LEXUS RX300 (RM785E)
3.
INSPECT IGNITION KEY ILLUMINATION OPERATION
Connect the positive (+) lead from the battery to terminal 1 and
the negative (–) lead to terminal 2, and check that the indicator
light lights up.
If operation is not as specified, replace the switch.
4.
INSPECT IGNITION KEY ILLUMINATION CIRCUIT
(See page DI–588)
5.
INSPECT KEY UNLOCK WARNING SWITCH CONTI-
NUITY
Switch position
Tester connection
Specified condition
OFF (Key removed)
–
No continuity
ON (Key set)
1 – 2
Continuity
If continuity is not as specified, replace the switch.
6.
INSPECT KEY UNLOCK WARNING SWITCH CIRCUIT
(See page DI–590)
Connect the switch connector and inspect the connector on
wire harness side from the back side, as shown.
Tester connection
Condition
Specified condition
1 – Ground
Constant
Continuity
If circuit is not as specified, inspect the circuits connected to oth-
er parts.
I19162
Headlight
Automatic Light Control Sensor
Ignition Switch
Taillight
R/B No.3 (LHD)
D DRL No.2 Relay
Engine Room J/B
D H–LP R LWR Fuse
D H–LP L LWR Fuse
D Headlight Control Relay
R/B No.2
D H–LP R UPR Fuse
D H–LP L UPR Fuse
Key Unlock Warning Switch
Combination Switch
D Light Control Switch
D Headlight Dimmer Switch
Instrument Panel J/B
D TAIL Fuse
D Taillight Control Relay
Driver Door
Courtesy Switch
BE04W–07
BE–28
–
BODY ELECTRICAL
HEADLIGHT AND TAILLIGHT SYSTEM
LEXUS RX300 (RM785E)
HEADLIGHT AND TAILLIGHT SYSTEM
LOCATION
BE04X–07
I04473
Combination Switch
D Light Control Switch
D Headlight Dimmer Switch
Switch Body
D Wiper and Washer Switch
Combination Switch
Spiral Cable
–
BODY ELECTRICAL
HEADLIGHT AND TAILLIGHT SYSTEM
BE–29
LEXUS RX300 (RM785E)
COMPONENTS
BE0U9–02
I04494
I04492
I04493
BE–30
–
BODY ELECTRICAL
HEADLIGHT AND TAILLIGHT SYSTEM
LEXUS RX300 (RM785E)
REMOVAL
1.
REMOVE COLUMN COVER
(a)
Remove the 3 screws.
(b)
Remove the column cover.
2.
REMOVE LIGHT CONTROL SWITCH
(a)
Disconnect the light control switch connector.
(b)
Remove the 2 screws.
(c)
Remove the switch.
3.
REMOVE WIPER AND WASHER SWITCH
(a)
Disconnect the wiper and washer switch connector.
(b)
Remove the 2 screws.
(c)
Remove the switch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст