Lexus ES300 (1997 year). Manual — part 565
RS013–02
RS–20
–
SUPPLEMENTAL RESTRAINT SYSTEM
STEERING WHEEL PAD AND SPIRAL CABLE
1364
1997 LEXUS ES300 (RM511U)
INSTALLATION
(See page
RS014–02
W03845
CD Auto Changer
Front Upper Panel
Front Passenger
Airbag Assembly
21 (210, 15)
No.1 Lower Retainer
A/C Unit Duct
Lower Instrument Panel
No.2 Under Cover
Lower Instrument Cover
Front Door Scuff Plate
Cowl Side Trim
N·m (kgf·cm, ft·lbf) : Specified torque
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
RS–21
1365
1997 LEXUS ES300 (RM511U)
FRONT PASSENGER AIRBAG ASSEMBLY
COMPONENTS
RS02P–01
H01349
W03622
RS–22
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
1366
1997 LEXUS ES300 (RM511U)
REMOVAL
NOTICE:
If the wiring connector of the SRS is disconnected
and the ignition switch is at ON or ACC position, DTCs
will be recorded.
Never use the airbag parts from another vehicle.
When replacing parts, replace with new parts.
1.
DISCONNECT AIRBAG CONNECTOR
(a)
Remove the lower instrument cover inside the No.2 under
cover.
NOTICE:
When handling the airbag connector, take care not to dam-
age the airbag wire harness.
(b)
Pull up the connector.
(c)
Disconnect the front passenger airbag connector.
2.
REMOVE THESE PARTS: (See page
(a)
Front door scuff plate
(b)
Cowl side trim
(c)
No.2 under cover
(d)
Lower instrument panel
(e)
No.1 lower retainer
(f)
Finish upper panel
(g)
CD auto changer
(h)
A/C unit duct
3.
REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
Remove the 2 bolts, 4 nuts and front passenger airbag assem-
bly.
CAUTION:
Do not store the front passenger airbag assembly
with the airbag deployment direction facing down-
ward.
Never disassemble the front passenger airbag as-
sembly.
RS02Q–01
W03614
W03619
W03846
W03620
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
RS–23
1367
1997 LEXUS ES300 (RM511U)
INSPECTION
1.
VEHICLES NOT INVOLVED IN A COLLISION
(a)
Do a diagnostic system check.
(See page
(b)
Do a visual check which includes the following items with
the front passenger airbag assembly installed in the ve-
hicle.
Check cuts, minute cracks or marked discoloration on the
front passenger airbag assembly and instrument panel.
2.
VEHICLE INVOLVED IN A COLLISION AND AIRBAG IS
NOT DEPLOYED
(a)
Do a diagnostic system check.
(See page
(b)
Do a visual check which includes the following items with
the front passenger airbag assembly removed from the
vehicle.
Check cuts minute cracks or marked discoloration
on the front passenger airbag assembly.
Check cuts and cracks in wire harnesses, and for
chipping in connectors.
Check the deformation or cracks on the instrument
panel and instrument panel reinforcement.
HINT:
If the instrument panel or instrument panel reinforcement
is deformed or cracked, never repair it. Always replace it
with a new one.
There should be no interference between the instrument
panel and the front passenger airbag assembly.
CAUTION:
For removal and installation of the front passenger airbag
assembly, see page
correct procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст