Lexus ES300 (1997 year). Manual — part 141
I01418
2
CLOCK LOSES OR GAINS TIME
(Clock Side)
(Wire Harness Side)
Is there 10 – 16 V between terminal +B and body
ground?
Below 10V
Detect cause and repair, or recharge battery.
Yes
Adjust or replace clock.
4
3 2
1
4
3
2
1
(a) Check that the battery positive voltage is 10–16 V.
If voltage is not as specified, replace the battery.
(b) Inspect the error of the clock.
Allowable error (per day):
±
1.5 sec.
If the error exceeds the allowable error, replace the clock.
(c) Check that the clock adjusting button is caught in position,
and does not return.
If the button is not returned, repair or replace the clock.
(d) Troubleshoot the clock as follows.
HINT:
Inspect the connector on the wire harness side.
BE–170
–
BODY ELECTRICAL
CLOCK
1554
1997 LEXUS ES300 (RM511U)
Z19485
Horn
Horn Switch
Engine Room
Junction Block
Horn Relay
HORN Fuse
BE067–01
–
BODY ELECTRICAL
HORN SYSTEM
BE–171
1555
1997 LEXUS ES300 (RM511U)
HORN SYSTEM
LOCATION
BE068–03
N21863
N21864
N10342
BE–172
–
BODY ELECTRICAL
HORN SYSTEM
1556
1997 LEXUS ES300 (RM511U)
INSPECTION
1.
INSPECT HORN SWITCH
(a)
Disconnect the negative (–) terminal from the battery.
(b)
Remove the left and right covers from the steering wheel.
(c)
Using a torx socket wrench, loosen the 2 bolts.
(d)
Pull up the horn pad and place it on the steering column,
as shown.
HINT:
Do not disconnect the connector from the horn pad.
(e)
Disconnect the connector from the slip ring.
(f)
Check that no continuity exists between terminal 6 of the
connector and body ground.
(g)
Check that continuity exists between terminal 6 of the
connector and body ground when the horn contact plate
is pressed against the steering spoke assembly.
If continuity is not as specified, repair or replace the steering
wheel or wire harness as necessary.
(h)
Install the horn pad in place and using a torx socket
wrench, torque the 2 bolts.
Torque:
7.1 N·m (72 kgf·cm, 62 in.·lbf)
(i)
Install the left and right covers.
(j)
Connect the negative (–) terminal to the battery.
2.
INSPECT HORN OPERATION
Connect the positive (+) lead from the battery to the terminal
and negative (–) lead to the horn body and check that the horn
blows.
If operation is not as specified, replace the horn.
N14863
1
2
5
3
3
1
5
2
–
BODY ELECTRICAL
HORN SYSTEM
BE–173
1557
1997 LEXUS ES300 (RM511U)
3.
INSPECT HORN RELAY CONTINUITY
Condition
Tester connection
Specified condition
Constant
1 – 2
Continuity
Apply B+ between
terminals 1 and 2.
3 – 5
Continuity
If continuity is not as specified, replace the relay.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст